Raypak PS270VSP Quick Start Manual

PS270VSP
Quick Star t Guide
WARNING: This product must be installed and serviced by a qualified pool professional,
and must conform to all national, state, and local codes. Before installing this product,
read and follow all warning notices and instructions of this product. Failure to follow
warning notices and instructions may result in property damage, personal injury, or
death.
User Interface & Navigation Over view
OVERRIDE
LOW
6
OVERRIDE
HIGH
CLEAN
5
NOTE: The selector knob must be
turned to RUN for the pump to oper-
ate. When the user presses ← or →
button the cursor moves to the next
or previous position. If the cursor is
at the end of a line when the user
presses the arrow, the cursor moves
to the next line.
Pre-set Schedule
Only the clock setting is required to enable the PS270VSP to operate at three different
speeds and durations using the pre-set schedule. The preset speeds and schedule
times are detailed in the manual on page 14.
„ Observe all safety warnings and cautions
„ Verify the user interface is plugged in
„ Make certain the motor is properly wired
„ Turn selector knob to SET CLOCK
„ Set the Time and Date using the +, -, ←, → buttons
„ Turn the Selector knob to RUN
NOTE: Must wait until "PRIME MODE" is complete to make changes to OVERRIDE
settings.
Catalog No. 6200.183
POWER
1
2
FAULT
3
BACK
+
SET
-
4
Controls &
LEDs Description
1 Display Screen
2 LED Lights
Power: Light (Green)
Fault: Light (Red)
3 BACK: returns to previous
program setting and does NOT
accept current screen values
4 Navigation Selector
„
selected value
„
„
5 Interface Selector
6 Override Buttons
Effective. 06/2013
+ or – increases/decreases
← or → Navigates to adjust-
able value (digit)
SET accepts the current
screen values
Replaces: NEW