EUTRAC 98-505 Series Installation Instructions

MultiCompactAdapter Standard
with data bus option
INSTALLATION INSTRUCTION
· READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE
INSTALLING THE EUTRAC TRACK SYSTEMS.
· SAVE THESE INSTRUCTIONS AND REFER TO THEM WHEN
ADDITIONS TO OR CHANGES IN THE TRACK CONFIGURATION
ARE MADE.
· Track is only to be used with other electrical ttings identi ed for use
with the EUTRAC track system 230/233 .
· To be installed by trained personnel only ( electricians ).
· The Installation and operation of this track system are subject to
national safety regulations.
The manufacturer is not liable for damage caused by improper
use or installation.
If any track system components is subsequently modi ed,
the person responsible for the modi cation shall be considered
as manufacturer.
· It is the responsibility of the installer to ensure the electrical,
mechanical and thermal compatibility of the track system
and the ttings.
· Materials used for ceiling xation should conform to the relevant
building regulations.
· It is essential to cover the ends of the track with end covers or
protective caps.
· This track system is not intended for use with a power supply cord
or convenience receptable adaptor.
TRACK LIGHTING FITTING
44WB
· INSTALLATION INSTRUCTIONS ·
2 Circuit ( 120V )
Tracks and Adaptors
www.EUTRAC.com
2~

IMPORTANT SAFETY INSTRUCTIONS

· READ ALL INSTRUCTIONS.
· Do not install this track in damp or wet locations ( IP20 , 45°C max.).
· Do not install any part of a track system less 5 ft. above the oor.
· Do not install any xture assembly closer than 6 in. from
any curtain or similar combustible material.
· Disconnect electrical power before adding to or changing the
con guration of the track.
· Do not attempt to energize anything other than lighting track
xtures on the track.
In order to reduce the risk of re and electrical shock, do not attempt
to connect power tools, extension cords, appliances and the like to
the track.
· ( For track lighting systems other than 120V, two circuit )
Do not connect the track to more than the branch circuit unless
the track is constructed so that it can be used with more than one
branch circuit.
Check with a quali ed electrician. Although the track lighting
system may seem to operate appropriately, a dangerous overload of
the neutral may occur and result in a risk of re.
· Do not slide light xtures along track when re-locating.
Always remove xture/adapter from track.
Re-install in new location making sure to properly secured
adapter back in track.
· SAVE THESE INSTRUCTIONS.
98-505-.
Page
07.09.2017
# 427806
MT 6.077/1
1/5