Hyperion IDS-CCULD Installation Instructions

Advertisement

INSTALLATION INSTRUCTIONS
IDS-CCULD
OVERVIEW
This document pertains to installation of IDS-CCULD. For additional information regarding device setup and configuration, refer to
the Hyperion User Manual (Document #7L761) on our website: http://www.wrensolutions.com/hyperion/hyperion_support/
Hyperion Enabled Ports
(
for Hyperion devices only)
Step 1 — Identify an appropriate
mounting location
Wall Mount
The CCULD should be mounted to a
structurally solid, wall surface using the
included bracket.
Mount by using the appropriate fasteners
and anchors for the mounting surface.
Fasteners and anchors are not provided.
Table Mount
The CCULD is equipped with rubber feet
for table mounting applications as well. The
feet are pre-installed.
Digital Inputs
Audio
Outputs
Out
Supplied Parts
IDS-CCULD
24VDC Power Supply
Ferrite Beads (x3)
Mounting Bracket
Antenna

Tools Required

Screw Driver, No. 2 Phillips
Drill
Mounting Hardware
Cat5 extension cables
Antenna
Power
Port
Input
Page 1 of 3
Network
Connection
7L766 Rev A
180501

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IDS-CCULD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hyperion IDS-CCULD

  • Page 1: Tools Required

    • Mounting Hardware • Cat5 extension cables OVERVIEW This document pertains to installation of IDS-CCULD. For additional information regarding device setup and configuration, refer to the Hyperion User Manual (Document #7L761) on our website: http://www.wrensolutions.com/hyperion/hyperion_support/ Antenna Power Network Digital Inputs...
  • Page 2 The Relay is rated for 250VAC/100VDC, 10 amps. Step 4 — Antenna Snugly hand tighten the included Antenna to the antenna jack on the IDS-CCULD. This Antenna is only required when using the optional IDS-RTCTOP. The Antenna needs to pointed as vertical as possible.
  • Page 3 INSTALLATION INSTRUCTIONS Step 5 — Audio Connections Refer to the image below if connecting this device to a speaker. The IDS-CCULD has 2 speaker outputs. The speaker outputs can also be adjusted here using the Volume adjustments. NOTE: • We recommend using 18 AWG wire or larger for the audio signal.

Table of Contents