TAPaulk Communications BT-M3 User Manual

BT-M3 Bluetooth Adaptor
BLUETOOTH ADAPTOR USER'S GUIDE
For Compatible Wireless Audio Accessories
The TAPaulk Bluetooth adaptor BT-M3 allows you
to use a compatible wireless headset or other audio
accessory with your two-way radio.
Bluetooth Adaptor
Model No.: BT-M3
Made in Taiwan
FCC ID: XTS-BTD-1M3
QUICK START
1. Connect the TAPaulk Bluetooth adaptor BT-M3 to a compatible two-way radio.
2. Pair the Bluetooth adaptor with a compatible wireless audio accessory.
3. Connect a wired audio or PTT accessory to the Quick-Disconnect accessory port
on the Bluetooth dongle (optional).
4. Test and use.
Connecting the Adaptor to Radio
STEP ONE: Connecting to Two-Way Radio
To connect your Bluetooth adaptor to a two-way radio, follow these steps:
* Always turn off your two-way radio before connecting the Bluetooth adaptor.
* Plug the Bluetooth adaptor BT-M3 into the speaker-microphone / audio accessory
jack of your two-way radio.
* On some models of two-way radios, you may need to tighten a retaining screw to
ensure that the Bluetooth adaptor remains attached to the radio
* Turn on your two-way radio and verify that the radio transmits and receives with
the adaptor attached.
* Because no wireless audio accessory will yet be paired to the Bluetooth adaptor,
Version 1.0 August 2013
received signals should be heard over the radio's internal speaker and transmitted
signals will be sent using the radio's internal microphone.
* The Talk button on the Bluetooth adaptor will not function as a Push-to-Talk
button for your two-way radio until a wireless audio accessory is successfully
paired to the adaptor, or a wired audio accessory is plugged into the
Quick-Disconnect port.
Controls and Connection
Quick Disconnect Accessory Port
Allows the connection of a
TAPaulk QD series wired
audio accessory, such as a
Push-to-Talk, earphone,
or speaker microphone.
Radio Connector
This port connects the Bluetooth adaptor
to a compatible two-way radio.
Pairing With an Audio Accessory
STEP TWO: Pairing with an Audio Accessory
* Turn off the radio that the Bluetooth adaptor is connected to. Wait at least three
seconds.
* Turn the radio on while holding down the Talk button on the Bluetooth adaptor.
* Continue to hold the Talk button down for approximately three seconds.
Release the Talk button when the status LED begins to flash two times per second.
* The Bluetooth dongle is now in audio accessory pairing mode. Activate the
pairing mode on your compatible wireless audio accessory.
* Once the wireless audio accessory and Bluetooth dongle are paired with each
other, the status LED on the dongle will show a constant blue light for three
seconds.
3
Multi-Function Talk Switch / Status LED
Used to place the Bluetooth adaptor in
pairing mode. The LED flashes messages
that let the user know the current status of
the Bluetooth adaptor. Once paired with an
audio accessory, this switch is used to
activate the Push-To-Talk function of the
two-way radio.
2