Multivoice MV-AUDIBLE Quick Start Manual

Turn me on
1
Choose 1 Intercom and . . .
Light will flash, then turn solid.
Push & Hold the Power Button.
NOTE #1: After you release the Power Button, the LED Light will
begin to flash again. This is normal.
NOTE #2: To TURN OFF a MULTIVOICE Intercom, press and hold the
Power Button until all Lights on the Intercom turn off. Your Intercom is
now turned off.
NOTE #3 FOR FOOTBALL USE: If you plan to use 1 or more MV-AUDIBLE
Intercoms in a Press Box during a game or practice, you must ensure
that A) You turn on these Intercoms first, and B) that you only use them
in the Press Box during said game/practice. Failure to do so may cause
temporary loss of communication.
Add more
4
Repeat Steps 1—3 above to add more MULTIVOICE Intercoms to your
network system.
NOTE: Each additional MULTIVOICE Intercom will be connected
to the other units in your system as soon as you complete the
steps in Section #1 above.
QuickStart Guide
MV-AUDIBLE™, MV-NEXUS™ and MV-PROTECTOR™
Connect headset
2
Connect one cable headset to a MULTIVOICE Intercom as shown below.
Align the Female Connector on the
Cable Slot...
After Light turns solid,
release Power Button.
...with the Pin inside the Male Connector
on the Intercom.
sound
5
Press to
Increase
Volume
Press to
Decrease
Volume
NOTE: If one of the Channel LED Lights are lit on your MULTIVOICE
Intercom, you will hear everyone speaking on that particular Channel.
If you want to BE HEARD
LED Lights on the front of your Intercom must also be lit. To enter Talk
Mode, please push the mic button, flip the switch on the Switch-to-Talk
box, or lower your boom mic so it is positioned in front of your mouth;
the Blue LEDs will light-up and you can now BE HEARD. To deactivate
your mic and return to Listen Mode, push the mic button or lift your
boom mic; the Blue LED Lights will now turn off.
multivoice™ Intercoms
Then push the cable Connector
Down and...
...Twist 1/4—turn to
Lock into place.
TM by others on that same Channel, the 2 Blue
Activate mic
3
Once a cable headset is connected to a MULTIVOICE Intercom, the
default setting is for the microphone to be turned on. You will know
your mic is "live" because the Blue LED lights on the front of your
Intercom are lit.
NOTE: You must have eight (8) or fewer Intercoms synchronized in a
MULTIVOICE network for each unit to have a "live" microphone. If you
are using 8 or fewer Intercoms, you can activate the mic by A) flipping
the switch on the Switch-to-Talk™ box between your Headset and
Intercom, or B) by pushing the microphone button on the front of the
Intercom, or C) by lowering the boom microphone on your Headset.
Changing channels
6
Example: Channel 2
NOTE: MULTIVOICE Intercoms come standard with 4-6
Channels, (4 channels for MV-AUDIBLE and 6 channels for
MV-NEXUS and MV-PROTECTOR) with each Channel LED Light
signifying the respective Channel, starting (from Left to Right)
with Channel #1 and ending with Channel #4 for MV-AUDIBLE
and Channel #6 for MV-NEXUS and MV-PROTECTOR. To change
from one Channel to the next, simply push the Channel Button
once. (See section #7 on the back page for more info.)
Channel Button