Mityvac DUAL CONVERTER Installation Instructions

DUAL CONVERTER
NOTE:READ THROUGH ALL INSTRUCTIONS AND FAMILIARIZE YOURSELF WITH THE PARTS
PRIOR TO INSTALLING YOUR DUAL CONVERTER
1. Make sure the exterior of your pump is cleaned of loose
dirt, grease, oil, etc.
2. Remove the old exhaust fitting
a. For plastic pump: Retain screws
b. For metal pump: Discard screws
3. Remove the old junction
a. For plastic pump: Retain screws
b. For metal pump: Retain screws
4. Install black exhaust valve in elbow. Install the elbow on
the pump. Do not overtighten.
For plastic pump: Use screws retained in step 2a.
For metal pump: Use the two larger screws provided.
a. For plastic Dual Converter
Select the correct exhaust elbow from the Dual
TM
Converter kit. (The elbow marked "M" is for the
metal pump; the one marked "P" is for the plastic
standard pump; the one marked "SP" is for the plastic
Superpump TM ).
b. For Silverline TM (metal) Dual Converter
Use the exhaust elbow provided in kit.
5. Slip the small O-ring onto elbow. Install the large O-ring
into Dual Converter TM frame. Slide the Dual Converter
into place on the pump body and elbow. Make sure the
elbow is fully seated and the frame is snug against the
body. Install rear screw (on side away from knob) and
tighten until just snug. Use one of the screws retained in
step 3.
FEBRUARY 2003
DUAL CONVERTER MODEL 06895
TM
INSTALLATION INSTRUCTIONS
TM (p/n 06895):
TM (p/n 04095):
TM
One Lincoln Way
St. Louis, MO 63120-1578
Phone +1.314.679.4200
Fax +1.800.424.5359
Form 822363
6. Turn knob to "Vacuum" position. (Note the large square
notch on rear side of the black rotary valve is pointing up,
toward elbow.) Remove the screw from knob, then
remove the knob from the shaft.
7. Slowly slide the black rotary valve completely out. Install
front screw. Use the remaining screw retained in step 3.
Tighten until snug. Snug rear screw again.
8. Make sure that all three O-rings are in their recesses,
and carefully push the rotary valve back into place.*
The large square notch must point up toward the elbow.
Replace the knob onto the rotary valve shaft, with the
wide flange pointing toward "Vacuum". If necessary,
wiggle it slightly to fully seat the knob, then replace the
screw.
Do not overtighten.
9. Install the pressure pad onto the handle.
Note: Silverline TM metal pump must have handle screw-
hole, to install pressure pad.
* If the O-rings have become dry, it helps to lightly lubricate
them with Silicone Oil or light grease.
Do Not Use Aerosol Lubricants.
USA
and MODEL 04095
© Copyright 2003
Printed in USA
Web site:
www.lincolnindustrial.com