Centralite 4200-C Manual

Troubleshooting Performing a Full Reset
My app/controller can't find the Smart Outlet. 1. Unplug the Smart Outlet from the wall outlet.
2. Press and hold the Smart Outlet's side button while
1. Move the Smart Outlet to a location closer to your
plugging the Smart Outlet back in.
smart home controller and repeat setup.
3. After the status LED turns ON, release the button.
2. Perform a full reset on the Smart Outlet (next page).
4. The Smart Outlet will now begin searching for a
controller to connect to.
My Smart Outlet has stopped responding.
1. Restart the Smart Outlet by unplugging it and then
plugging it back in.
2. Remove the device from your system using your smart
home controller's app and then perform a full reset
(next page). Finally, rediscover the device with your app.
Still having issues?
Our live support team is here to help!
They're awesome, give 'em a try.
Phone: 877-466-5483
E-mail:
support@centralite.com
Web: www.centralite.com
Hold down button
while plugging in.
Live support available Mon-Fri, 8am-5pm CST
authority to operate the equipment.
RF Exposure: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
device should be installed and operated with minimum distance 20cm between the radiator & your body.
IC NOTICE: This device complies with Canada Industry licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference; and (2) this device must accept any interference.
Including interference that may cause undesired operation of the device.
CAN ICES-3 (B)
Avis d'Industrie Canada
FCC NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two Le présent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exem pts de licence
conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference L'exploitation est autorisée aux deux conditions suivantes: 1) I'appareil ne doit pas produire de brouillage; et 2) I'utillsateur
received, including interference that may cause undesired operation. de I'appareil doit accepter brouillage radio électrique subi meme si le brouillage est susceptible d'encompromettre le
fonctionnement. mauvais fonctionnement de I'appareil.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential Cet appareil numériquie de la classe B est conforme à la norme NMB-003 du Canada. CAN NMB-3 (B)
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
body.
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies
the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre
separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to
la source de rayonnement et votre corps.
which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modi cations not expressly approved by the party responsible for compliance could void the user's
Manufactured by: Centralite Systems, Inc.
Hi!
I'm a Smart Outlet.
Let's get started.