HAKO 951 Instruction Manual

®
This soldering gun has a built-in feeding mechanism that enables soldering with one hand.
When using this unit for the first time, be sure to calibrate the tip temperature. Specific
information can be found in the instruction manual for your particular Hakko station.
When inserting solder, be sure to push up the trigger and insert the solder until the end of
the solder protrudes from the guide nozzle.
Packing List
Soldering gun
Applicable Models
In order to function, the Hakko 951/952 must be connected to one of
the following Hakko stations: Hakko 700, 701, 702, 702B, 926, 927,
928, 936, 937.
Specifications
Name Hakko 951
Power consumption AC 24 V 50 W
Temperature range 200 C–480 C/392 F–896 F
Tip to ground
Under 2
resistance
Tip to ground potential Under 2 mV(TYP. 0.6 mV)
Heating Element Ceramic heater
Shape-3C
Standard tip Pre-tinned surface 55
(No.900M-T-S10)
Standard guide nozzle
ø1.0 mm (0.039 in.)
(Solder diameter)
ø0.6, 0.8, 1.0, 1.2 1.6 mm
Usable solder diameter
(ø0.024, 0.031, 0.039, 0.047, 0.063 in.)
Cord assembly 1.1 m (3.6 ft.)
Total length (w/o cord)
180
H W D
Weight (w/o cord) 177 g (0.39 lbs.)
*Specifications and design are subject to change without notice.
Instruction Manual
Thank you for purchasing the Hakko 951/952 soldering gun.
Please read this manual before operating the Hakko 951/952.
Keep this manual readily accessible for reference.
Hakko 952
Shape-B
(No.900L-T-B)
170 23 mm (7.1 6.7 0.9 in.)
187 g (0.41 lbs.)
CAUTION
Precautions
Warnings and cautions are placed at critical points in this manual
to direct the operator's attention to significant items. They are
defined as follows:
WARNING: Failure to comply with a WARNING may result in serious
injury or death.
CAUTION: Failure to comply with a CAUTION may result in injury
to the operator, or damage to the items involved. Two
examples are given below.
When power is ON, tip temperatures will be between 200 C and
480 C. (392 F to 896 F.) To avoid injury or damage to personnel
and items in the work area, observe the following:
Do not touch the tip or the metal parts near the tip.
Do not allow the tip to come close to, or touch, flammable materials.
Inform others in the area that the unit is hot and should not be
touched.
Turn the power off when not in use, or left unattended.
Turn the power off and allow the unit to cool to room temperature
when changing parts or storing the Hakko 951/952.
To prevent accidents or damage to the Hakko 951/952, be sure to
observe the following:
Do not use the unit for applications other than those specifically
described in the instruction manual.
Before using the Hakko 951/952 for the first time, calibrate the tip
temperature.
Do not strike the gun against hard objects to remove excess solder.
This will damage the gun.
Do not modify the Hakko 951/952.
Use only genuine Hakko replacement parts.
Do not allow the Hakko 951/952 to become wet, or use it when hands
are wet.
Be sure the work area is well ventilated. Soldering produces smoke.
Remove power and gun cords by holding the plug – not the wires.
1
WARNING
CAUTION
CAUTION