Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Peavey MAX 100
Summary of Contents for Peavey MAX 100
- Page 1 Series Bass Amplifiers ® Operating Manual www.peavey.com...
- Page 2 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, that may cause undesired operation. Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the user’s authority to use the equipment.
- Page 3 Contour, Mid-Shift and Bright. The MAX 100, MAX 150, MAX 250, and MAX 300 also feature a built-in chromatic tuner with mute, a tuned and ported enclosure, 1/8" headphone output and 1/8" auxiliary input. All models include an XLR direct output with ground lift, while the MAX 250 also has a built-in tweeter.
- Page 4 ® Control Panel MAX Series (1) ACTIVE/PASSIVE PICKUP Inputs These 1/4" inputs are included so you can choose the appropriate setting for your instrument. The gain structure of the amplifier is modified to accommodate the outputs of different pickup configurations. The PASSIVE input is 10dB hotter than the ACTIVE input. (2) GAIN This knob controls input level to the preamp.
- Page 5 (13) TUNE/MUTE (not available on Max 208) Pressing this button will engage the chromatic tuner while muting the output to the speaker. The LED screen will indicate which note is being played while the red and green LEDs above the screen indicate whether the note is flat (red), sharp (red) or in tune (green). This switch also mutes the DI.
- Page 6 (21) PRECISION BALANCED DIRECT INTERFACE This XLR output is used to connect the Max pre amp section to external equipment, such as mixing consoles, external power amplifiers, or recording equipment. This novel circuit provides a perfectly balanced and noise-free signal with none of the problems associated with small transformers.
- Page 7 POWER AMPLIFIER: (Rated Power)--Continuous RMS (1% THD, 1KHz sine wave, nominal line) MAX 100 = 60 W (rms) into 8 ohms MAX 150 = 120 W (rms) into 4 ohms MAX 250 = 150 W (rms) into 4 ohms MAX 300 = 200 W (rms) into 3 ohms...
- Page 8 Warranty registration and information for U.S. customers available online at www.peavey.com/warranty or use the QR tag below Features and speci cations subject to change without notice. Peavey Electronics Corporation 5022 Hartley Peavey Drive Meridian, MS 39305 (601) 483-5365 FAX (601) 486-1278 Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005...