Yamaha YP-D6 Owner's Manual page 9

ADJUSTING THE STYLUS TRACKING FORCE
Some cartridges have detachable stylus guards,
and others have hinged protection. The cartridge
shoud be in the same state it would be for actu-
al record audition, with the stylus fully exposed.
Take care not to "snag" the stylus while it is un-
protected.
1. Set the inside-force canceler dial to zero ('0').
2. Lift the tonearm fro the arm rest, and move
to a point on the right of the arm rest (i.e.
outside it) as shown.
3. Turn down the cueing lever (arm lifter) as
shown, and allow the arm to find its own posi-
tion. If necessary, support the headshell with
the finger grip to prevent the stylus from cont-
acting the motor board.
4. Slowly rotate the balacne counterweight as-
sembly in the direction indicated until the tone-
arm is perfectly balanced, parallel with the
motor board. A very small
should be made at a time, unitl the headshell
floats freely, no longer needing to be supported.
5. Return the tonearm to the arm rest once per-
fect balance has been achieved.
rotation only
8