PowerMadd 34291 Installation Instructions

Star series turn signal kit

Hide thumbs

Table of Contents

Quick Links

Download this manual

Star Series Turn Signal Kit

Installation Instructions for Part No. 34291

Hardware Included:

1 – Pair Street LED vent covers

1 – LED module

4 – T-taps

4 – Space terminals

6 – Cable ties

4 – Small screws

4 – Small washers

We thank you for purchasing the PowerMadd Star Series LED Turn signal light kit. This kit is intended to be

used with PowerMadd Star Series Handguards and model specific Handguard bracket kits for Harley Davidson

motorcycles. Installation should be installed by a certified Harley Davidson technician and the use of the

factory service Manual for proper installation. PowerMadd accepts no liability for damages caused by improper

installation.

Warning:

Disconnect negative battery cable from battery before any work is performed. Refer to Harley

Davidson owner's manual. Failure to do so may result in electrical shock, injury, or fire. Make sure to Secure

negative battery cable away from positive side of battery and all other positive voltage sources on the

motorcycle.

Wiring Diagram:

Note:

Handguards and Bracket kits must be installed onto motorcycle before the Led light kit is

installed. Please refer to the handguard specific installation instruction.

STEP 1:

Start by removing the original vent cover from your Star series

handguards by first unsnapping the bottom three tabs from the

inside of each vent cover. Then pop the vent cover out from the

front side of the handguard.

STEP 2:

Drill a 7/16 hole in the inside corner of the star series handguard

as shown in Photo.

Install the LED light vent cover assembly by carefully feeding

the LED light wire through the vent hole that you previously

opened up. Take care when handling the LED Vent Cover.

Note: it is possible for the LED light to become detached. If this

happens, simply snap the LED light back into the vent cover.

Snap the LED vent cover in place by inserting the top three tabs

of the vent cover into the vent holes, next press on the bottom

front section to snap the lower three tabs into place.

651-462-8465

Tools Required:

Drill

7/16" drill bit

Phillips screwdriver

M34291 Rev A

www.powermadd.com

Table of Contents

Need help?

Do you have a question about the 34291 and is the answer not in the manual?

Questions and answers

Summary of Contents for PowerMadd 34291

Page 1 4 – Small screws 4 – Small washers We thank you for purchasing the PowerMadd Star Series LED Turn signal light kit. This kit is intended to be used with PowerMadd Star Series Handguards and model specific Handguard bracket kits for Harley Davidson motorcycles.
Page 2 Left turn signal wire labeled “left” Tap into the yellow turn signal wire with a supplied 3M T-tap. See T-Tap instructions on page 3 Crimp a spade terminal to the wire labeled “left”. © 2018 PowerMadd M34291 Rev A 651-462-8465...
Page 3 POWERMADD shall not be liable for damage or injury caused by defective materials or workmanship. POWERMADD may elect to repair or replace this product, but is the sole judge of any defects in their product. This warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original purchase date.