Table of Contents
Advertisement
Quick Links
Wireless DMX
Transmitter/Receiver/Splitt
Instruction Manual
Models:
DST8W-3 PRO, DST8W-5 PRO
DST8W-C PRO
version 1.0 since 2 June 2017
ATTENTION!
This instruction manual contains important information about the installation and the use of the
equipment. Please read and follow these instructions carefully.
Always ensure that the power to the equipment is disconnected before opening the equipment or
commencing any maintenance work.
DSR8W-PRO_en_manual_M077
Advertisement
Table of Contents
Summary of Contents for SRS Labs DST8W-3 PRO
- Page 1 Wireless DMX Transmitter/Receiver/Splitt Instruction Manual Models: DST8W-3 PRO, DST8W-5 PRO DST8W-C PRO version 1.0 since 2 June 2017 ATTENTION! This instruction manual contains important information about the installation and the use of the equipment. Please read and follow these instructions carefully.
- Page 2 IMPORTANT SAFETY INFORMATION The following general safety precautions have to be observed during all phases of operation, service, and the repair of this equipment. Failure to comply with these precautions or with specific warnings in this manual violates safety standards of design, manufacture, and the intended use of this equipment.
-
Page 3: Front Panel
Front panel: Rear panel: Device use: By default, Power LED indicates that DSR8W is on main power. When the power light is off, check the main power input. DSR8W can be used as usual DMX splitter, W-DMX receiver or splitter with 8 outputs. W-DMX signal does not affect the IN/THRU outputs. - Page 4 DMX operation For the DMX operation, turn off the W-DMX module by holding the MODE button until both W-DMX and mode buttons are lit in red color. W-DMX module is now turned off. Now just connect the DMX cable to DMX IN connector and use DSR8W as standard DMX isolated splitter one to eight.
- Page 5 W-DMX operation: Transmitter For the W-DMX operation, turn on the W-DMX module by holding the MODE button + the W- DMX function button until both light in green color + the W-DMX is slowly changing color. The Transmitter operation is indicated by changing of three green Bargraph LEDs in effect of transmitting.
- Page 6 W-DMX PRO functions 1. W-DMX is turned off. DSR8W is 4. The W-DMX is linked to the used as a DMX splitter. To turn Transmitter and receiving the the W-DMX on, hold the mode DMX signal. Both indicators are button for 3 sec. To turn it off, green.
-
Page 7: Technical Data
Device in use / service: Should there problem, do not hesitate contact sales@srs-group.com or +421244681417 and stay calm. We will help you fix your problems for sure. Technical data Mains input: AC 100-255V / 50-60Hz / 15W Input / Output: 8x USITT DMX512 /RS485/ isolated up to 1000V W-DMX port compatible with W-DMX Transmitters Size:... - Page 8 Copyright 2017 SRS Group, s.r.o. | Specifications subject to change without notice. Document: DSR8W-PRO_en_manual_M077 | Version 1.0 | Actual as of: 2 June 2017 SRS Group s.r.o. Rybnicna 36/D | 831 07 Bratislava | Slovakia Phone: +421 2 44 681 417 | Fax: +421 2 4468 1419 Email: sales@srs-group.com | www.srs-group.com ( 8 / 8)
Need help?
Do you have a question about the DST8W-3 PRO and is the answer not in the manual?
Questions and answers