Advertisement
Trim flush with
power supply
edge
3A
For GEPS24-100U-GLX only: On the AC input end of
power supply, trim or grind sides of mounting tab flush
with power supply. Then slide junction box onto AC input
end of power supply and align mounting holes. Ensure
power supply mounting tab is inside the junction box.
4
Mount and secure Junction Box and Tetra Power Supply
using #6 or #8 screws and star-type lock washers in
both holes.
6
Connect Tetra Power Supply to AC
line per instructions enclosed with
the power supply.
All trademarks are the property of their respective owners. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory
conditions. Current, powered by GE is a business of the General Electric Company.
© 2018 GE.
www.currentbyge.com
Power supply
mounting tab is
inside junction box
7
Neatly fold wires within the Junction
Box and reattach cover with mounting
screw and washer. Tighten securely.
Conforms to the following standards:
SIGN108 (Rev 08/24/18)
Power supply mounting tab
is under junction box
3B
For all other power supplies: Slide junction box onto
AC input end of power supply and align mounting holes.
Ensure power supply mounting tab is under the junction
box.
5
Connect AC line ground wire to Junction Box ground
screw.
8
Complete installation. Continue with
LED light engine connections.
Advertisement
