Connecting To An Access Point In Infrastructure Mode; How To Configure An Infrastructure Mode Profile - NETGEAR RangeMax WN511T User Manual

Next wireless pc card

Hide thumbs Also See for RangeMax WN511T:

Table of Contents

NETGEAR RangeMax Next Wireless PC Card WN511T User Manual

There are two types of wireless network connections you can configure:

•

Infrastructure Mode — uses the 802.11 infrastructure mode.

•

Ad-hoc Mode — uses the 802.11 ad-hoc mode

For more information on 802.11 wireless network modes, see

on page B-1

of this manual.

Connecting to an Access Point in Infrastructure Mode

Figure 4-1: WN511T Wireless PC Card connecting to a wireless access point.

Follow the instructions below to configure an infrastructure mode profile for connecting to an

access point.

1. Run the WN511T Smart Wizard Wireless Assistant.

a. Make sure the WN511T software is installed and the WN511T is fully inserted in an

available CardBus slot in your PC.

b. Click the WN511T icon

Wireless Assistant.

4-2

in the Windows system tray to open the Smart Wizard

March 2006

"Wireless Networking Overview"

Configuration

Table of Contents