Riedel RiFace Installation Manual

RiFace Installation Guide
This guide describes the steps to install the radios in the RiFace rack.
A T10 Torx driver and a 4mm hexagon driver are required for the assembly.
All different radio types are mounted in the same way. Only the connectors can vary in type.
Following table shows the different RiFace versions with the compatible radios.
RiFace
1550200 RiFace G2 GM360 Simplex
1550210 RiFace G2 GM360 Duplex
1550220 RiFace G2 CM300 Simplex
1550230 RiFace G2 CM300 Duplex
1550240 RiFace G2 DM3400 Simplex
1550250 RiFace G2 DM3400 Duplex
1550260 RiFace G2 MTM700 Simplex
1550270 RiFace G2 MTM700 Duplex
1550280 RiFace G2 MTM800e Simplex
1550290 RiFace G2 MTM800e Duplex
2. Turn the top plate to the back side
and unplug the grounding connector
from the grounding terminal on the
top plate.
5. Slide the locking PCB in the notch of
the radio connector.
Riedel Communications GmbH & Co. KG
Radios
Motorola
GM360/GM340/CM360/Pro5100/CDM1550
Motorola
CM300/CM340/CM360
Motorola
DM3400/DM3600/XPR4550
Motorola
MTM700/MTM800
Motorola
MTM800e
3. Unplug carefully both audio cables
from the PCB connector.
6. Plug the connector PCB on the radio
connector and fix it on the locking
PCB.
| Uellendahler Str. 353 | 42109 Wuppertal | Germany
1. Remove the 13 screws on the top.
4. Remove both screws of the
connector PCB.
7. Slide the radio in the rack and plug
the audio cables (left cable faces left,
right cable faces right).
www.riedel.net