Advertisement
WARNING:
I
mportant safety InstructIon
NOTE: Always adhere to installation / usage instructions and warning. Improper use may result in injury, damage or
hazardous spill.
1. Turn off dispenser and relieve line pressure.
2. Apply DEF compatable thread sealant to NPT threads of mating fitting.
3. Only connect to DEF compatible and 304 stainless steel fittings - see page 2 for
4. Install at the nozzle or other appropriate location for 1" BSPP Male x 1" NPT Female
fittings.
5. Tighten firmly, approximately 15 - 20 lbf•ft / 20.3 - 27 N•m, but do not overtighten.
6. Pressurize system and visually check for leaks.
VERIFY SMOOTH ROTATION OF ALL SWIVEL JOINTS AFTER INSTALLATION.
• Turn off dispenser and relieve line pressure.
• Inspect the entire dispensing system for damage.
• Pressurize system and visually check for leaks.
• Check for smooth rotation of all swivel joints.
• Measure gap at joint - if a credit card fits in the gap (0.03 in / 0.76 mm) do not reinstall.
• Check for electrical conductivity.
TESTING / MAINTENANCE / INSPECTION
Daily
• Check for leaks / stains
• Check for damage
• Check for smooth rotation of all
swivel joints.
Monthly
• Measure gap at joint - a credit
card should not fit in the gap
(0.03 in / 0.76 mm).
• Check "remove after" date.
Annually
• Check for electrical conductivity
MADE IN THE USA
Husky Corporation • 2325 Husky Way • Pacific, MO 63069 • Phone: (800) 325-3558 • Fax: (636) 825-7300 • www.husky.com
Recommended Installation, Maintenance
and Inspection Instructions
Diesel Exhaust Fluid (DEF) Swivels
Designed for use in Diesel Exhaust Fluid (DEF)
dispensers only.
-
save these InstructIons In a readIly accessIble locatIon
INSTALLATION INSTRUCTIONS
DO NOT OVERTIGHTEN
IF DRIVE OFF OCCURS
Model 008510
• Only clean / rinse exterior surfaces
of DEF product with deionized water.
• All drive aways, maintenance and
inspection activities must be logged
using the serial number of the
individual product.
• Apply city, state, or federal testing
regulations as appropriate.
ANY TEST / INSPECTION
FAILURE REQUIRES IMMEDIATE
EQUIPMENT REPLACEMENT OR
REMOVAL FROM SERVICE.
Page 1
.
009338-5 9/2018
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Husky 008510
- Page 1 FAILURE REQUIRES IMMEDIATE • Check for electrical conductivity EQUIPMENT REPLACEMENT OR REMOVAL FROM SERVICE. MADE IN THE USA Husky Corporation • 2325 Husky Way • Pacific, MO 63069 • Phone: (800) 325-3558 • Fax: (636) 825-7300 • www.husky.com Page 1 009338-5 9/2018...
- Page 2 APPLICABLE SEAL CONFIGURATIONS Model 008510 Swivel thread type: 1 x 11 Male BSPP thread one end; 1 x 11 1/2 Female NPT other end. Option 2 Option 1 ▪ Seal is in mating device port. ▪ Seal formed by Husky o-ring.
- Page 3 (i) damage is obvious when the product is removed from shipping carton and (ii) the defective product is returned to Husky prior to use. This warranty does not apply to equipment or parts which have been installed improperly, damaged by misuse, improper operation or maintenance, or which are altered or repaired in any way.
Need help?
Do you have a question about the 008510 and is the answer not in the manual?
Questions and answers