Advertisement
INSTALLATION INSTRUCTIONS:
1.
Unhook fog light wiring harness
2.
Remove the bottom rubber sheild
3.
Remove the side bumper bracket bolts.
Two on each side.
4.
Remove the factory bumper by removing
the four 18mm bolts. Two on each side.
5.
Remove the tow hooks. There are three
15mm bolts holding each tow hook.
6.
Note: Before installing the mounting
plates, make sure the top of the frame
rails and the bottom sides of the mount-
ing plates are free of splatter.
7.
There is a driver and passenger mounting
plate. Use the 1/2" x 1 3/4" bolts, washers
and lock nuts to install mounting plates.
8.
Mount the Horizon Front Bumper to the
mounting plates by using the 1/2" x 2"
bolts, washers and lock nuts.
9.
Center the bumper from side to side and
raise or lower the bumper as needed.
10.
Mount the license plate using 1/4" bolts.
11.
There are two Flood Lights and two Spot
Lights. It is recommended to mount the
flood lights in the outside holes and the
spot lights to the inside holes. (Note: for
off road use only!)
12.
Make sure all nuts and bolts are tight!!
2011-16 Ford Super Duty
Horizon Front Bumper
HFF111BMT
TOOLS REQUIRED
Metric & SAE Sockets
Metric & SAE Wrenches
Learn more about off-road bumpers on our website.
Advertisement
