Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Logan 85-Ton Open Loop Power Swivel
- Page 1 85-Ton Open Loop Power Swivel...
-
Page 2: Table Of Contents
Skid-Mounted Unit ...............23 Hydraulic System and Controls ...........24 Torque Controller (for Air and Electric Controls) ....25 Assembly and Replacement Parts Lists Floating Washpipe ..............8 Power Swivel ............... 11 Power Unit ................21 Torque Controller ..............25 1 • Logan 85-ton Open Loop Power swivel... -
Page 3: Overview
Power Swivel. hose reels to form a rugged unit. A swivel carrying stand is standard. Logan 85-Ton Open Loop Power Swivel • 2... -
Page 4: Construction
The bail, torque. protected by a steel frame. bail pins, and body are tested to API guidelines. 3 • Logan 85-Ton Open Loop Power Swivel... -
Page 5: Basic Power System
Gooseneck Trailer-Mounted Unit, Side View fluid. Visual registers on the suction filter and high pressure loop filters indi- cate when these elements need to be replaced. Logan 85-Ton Open Loop Power Swivel • 4... -
Page 6: Pre-Operation Start-Up Procedure
It should the right-hand engine panel if it has than 5" Hg. not read over 5" Hg. been tripped. 5 • Logan 85-Ton Open Loop Power Swivel... -
Page 7: Operation
The Logan 85-Ton Open Loop Power 5. Charge pressure and suction gauges Swivel is now ready for operation. should be monitored daily. 6. Do not permit hydraulic oil temper- ature to exceed 190°F for extended periods. Logan 85-Ton Open Loop Power Swivel • 6... -
Page 8: Maintenance
Green indicates that the filter is in satisfactory condition. The filter indicator operates when the swivel is rotating to the right. 7 • Logan 85-Ton Open Loop Power Swivel... -
Page 9: Floating Washpipe Assembly
LKWA-500 1/2" Lock Washer ACSA8-625-13-150 5/8" - 13 x 1-1/2" Socket Head Cap Screw PS19028 Bonnet LKWA-625 5/8" Lock Washer 568-236 O-Ring PS49028 Washpipe PS79028 Upper Packing Nut Ring PS69028 Spacer and Lantern Ring PS50732-003 1/2" - 13 NC x 3/4 Socket Set Screw PS63672 Packing Nut Grease Fitting PS20128 Washpipe Packing Nut Screw Retainer PS62327 Plain Spacer Ring PS99028 Washpipe Locking Pin PS42327 Packing Bottom Ring 568-010 O-Ring PS29028 Lower Packing Nut Logan 85-Ton Open Loop Power Swivel • 8... - Page 10 1. Trailer hitch and safety chain 2. Brakes and tires 3. Tail and brake lights, and turn signals 4. Reserve fuel supply 5. Trailer tongue jack and supports Gooseneck Trailer-Mounted Unit, Rear View 9 • Logan 85-Ton Open Loop Power Swivel...
-
Page 11: Swivel Disassembly
A putty knife or other overnight without a coating of pro- the washpipe if it shows any signs of thin tool may be used for prying and tective oil. wear (scoring or surface abrasion). cleaning. Logan 85-Ton Open Loop Power Swivel • 10... -
Page 12: Power Swivel
Torque Rein Eye 86 PS12165 Second Reduction Gear PS21415 Torque Rein Pull Pin PS53775 Upper Gear Cover Plate 43 PS91875 Upper Gear Cover Shim 88 PS03165 Final Reduction Pinion PS85-OL-KM40.109 Hydraulic Motor (Open Loop Gear) PS95516-001 Motor Guard 45 PS65895-OL Hydraulic Motor Manifold Assembly PSWB3 Hose Safety Cable 47 ACSA8-375-13-275 3/8" - 13 x 2-3/4" Long, Socket Head Cap Screw G14085-001 2.5 Gal HD-85W-140 Gear Lube 48 LKWA-375 3/8" Lockwasher 11 • Logan 85-Ton Open Loop Power Swivel... -
Page 13: Front View
Swivel head – Front View Refer to Parts List on page 11 for part numbers and descriptions Logan 85-Ton Open Loop Power Swivel • 12... -
Page 14: Side View
Swivel head – Side View Refer to Parts List on page 11 for part numbers and descriptions 13 • Logan 85-Ton Open Loop Power Swivel... -
Page 15: Top View
Swivel head – Top View Refer to Parts List on page 11 for part numbers and descriptions (See page 15 for Section A-A) 13 14 24 25 13 21 (See page 15 for Section A-A) Logan 85-Ton Open Loop Power Swivel • 14... -
Page 16: Section A-A - Through Gear Train
Section A-A – Through Gear Train Refer to Parts List on page 11 for part numbers and descriptions 15 • Logan 85-Ton Open Loop Power Swivel... -
Page 17: Swivel Reassembly
Lay the lower be replaced. cover gasket on the face. Position the lower cover plate on the body and insert the cap screws with lock washers. Tighten the screws. Logan 85-Ton Open Loop Power Swivel • 16... - Page 18 23. Reattach all piping to the hydraulic motors before reattaching the motor guard. 17 • Logan 85-Ton Open Loop Power Swivel...
-
Page 19: Troubleshooting
Turn the bolt to midpoint and fasten the lock nut. Displacement control adjustment is not centered. Consult hydro-transmission manual. Logan 85-Ton Open Loop Power Swivel • 18... -
Page 20: Specifications
60.7/3,000 * Choice of Cummins, Caterpillar/Perkins, or John Deere CAUTION: Before installing a Logan 85-Ton Open Loop Power Swivel on a rig, refer to the installation procedure on page 4. Failure to install the Power Swivel properly can result in injury to the operator and rig floor personnel... -
Page 21: Swivel Head Dimensions
Swivel head – Dimensions Ø 5 Ø 2-7/8 20-17/32 2" NPT PLUG 53-15/16 4-1/32 13-23/32 19-1/2 23-5/32 2-1/2 API LINE PIPE 18-1/2 20-15/16 32-7/16 16-5/32 2-7/8 API IF 41-7/32 CLOSED 58-17/32 OPEN Logan 85-Ton Open Loop Power Swivel • 20... -
Page 22: Power Unit
John Deere Oil Filter MISCELLANEOUS PSP550759 John Deere Fuel Filter PSMM9000-002 Electric Winch PSAF1640 John Deere Primary Air Filter PS558612-001 Hydraulic Winch PSBattery Box Battery Box PSTool Box Tool Box PS211412 Power Swivel Stand 21 • Logan 85-Ton Open Loop Power Swivel... -
Page 23: Bumper Pull Trailer-Mounted Unit
Pull Trailer-Mounted Unit 97-3/4" 79-1/2" 232-1/2" The hydraulic system has been omitted from the drawing for clarity. Please refer to the hydraulic schematic on page 24. Logan 85-Ton Open Loop Power Swivel • 22... -
Page 24: Skid-Mounted Unit
Skid-Mounted Unit 87" 79-1/2" 74" 187" The hydraulic system has been omitted from the drawing for clarity. Please refer to the hydraulic schematic on page 24. 23 • Logan 85-Ton Open Loop Power Swivel... -
Page 25: Hydraulic System And Controls
Schematic Logan 85-Ton Open Loop Power Swivel • 24... -
Page 26: Torque Controller (For Air And Electric Controls)
TORQUE CONTROLLER ASSEMbLY (PS223612-OL) REPLACEMENT PARTS Item Logan Part no. Qty DescrIPtIon Item Logan Part no. Qty DescrIPtIon PS22236-OL 0 - 3,356 ft/lbs Torque Gauge PS2405-04-08 1/4" Male x 1/2" Female Bushing PS223612-001 Torque Set Panel PS2501-04-04 1/4" Male x 1/4" Male 90 Degree PS220512 Air Valve Push Button PS2404-04-02 1/4" Male x 1/8" Male Connector PS98126 Torque Release Valve LKWA-625 1/4" MT x 1/4" MT x 1/4" MP Tee PS2501-04-02 1/4" Male x 1/8" Male 90 Degree 25 • Logan 85-Ton Open Loop Power Swivel... - Page 27 Logan 85-ton Open Loop Power swivel • 26...