Advertisement
There following languages available to display the weekday:
German (GER)
English (ENG)
Danish (DAN)/
Spanish (ESP)
Dutch (NET)
Italian (ITA)
French (FRA).
Note: If there is no input for more than 30 seconds, the system returns to normal time display
mode. All settings changed that far will be saved. Press and hold the (B5) or (B3) buttons for
approx. 2 seconds to adjust the values in quick mode.
Note:
The German time signal can also be received all over Europe e.g. in England and Portugal. To
compensate for the time difference, you may open the settings and adjust the existing difference
by selecting the corresponding time zone of the respective country. Manual setup of the clock is
now complete.
Setting alarm time "Alarm 1" and "Alarm 2"
Use this radio clock to set and save up to two different alarm times.
1. Press and hold the SET button (B6) (alarm time 1), until the hour digits of alarm time 1 start
flashing in the display. "A1" appears in the display.
2. Press the (B5) or (B3) buttons to adjust the hours.
3. Press the MODE button (B4) to confirm your settings. The minutes start flashing.
4. Press the (B5) or (B3) buttons to adjust the minutes.
5. Press MODE (B4) again to confirm. The weekday area starts flashing. You can select the
weekdays on which the alarm should sound. Press the (B5) or (B3) buttons to select "M-F" for
Mondays through Fridays, "S-S" for Saturdays and Sundays, or "M-S" for Mondays through
Sundays. Press MODE (B4) to confirm. The alarm time 1 will be saved but not activated.
6. In order to set alarm time 2, press and hold the SET button (B2) (alarm time 2), until the hour
digits of alarm time 2 start flashing in the display. "A2" appears in the display.
7. Repeat the above steps for setting alarm time 2. Setting the alarm.
OPERATION MANUAL
RADIO ALARM CLOCK
EAN 4 0 1 7 8 0 5 5 1 5 0 2 4
5
Advertisement
