LorexBaby BB2415AC1 Quick Start Manual

ADD-ON CAMERA
BB2415AC1
QUICK START GUIDE

Getting Started

Connect the power adapter to the camera and
1
then to a power outlet.
Make sure all power cables are at least 3ft / 1m
away from the crib and out of reach of your child.
Pairing the Camera with Your Monitor
Place the camera and monitor next to each other. Make sure the
1
camera and monitor are turned on.
2 Press and hold on your monitor until the screen looks like the
figure below.
Press to select the channel you would like to pair the
3
camera to.
NOTE:
If a camera is already connected to this channel, the new
camera will replace the existing camera.
www.lorexbaby.com
1-20022013
What's Included
x1 x2 x1
Slide the power switch
TIP
2
to ON.
Press on your monitor to begin pairing. The LINK LED
4
flashes to show that pairing mode is on.
5 Press the PAIR button on the bottom of the camera.
Video from the camera is immediately shown on the
monitor once the camera has been successfully paired.
C1 
NOTE: Immediately move the camera away from the
monitor to avoid speaker feedback.
NOTE: If pairing was unsuccessful, repeat steps 2 to 5
of the pairing process.
BB2415AC1_Quick Start Guide_R1
Use the included cable clips to help keep
power cords away from your child.
Cable clips
PAIR
Page 1