Summary of Contents for Gravitech ARM-JTAG1
- Page 1 ARM JTAG-ICE Debugger and Programmer Model No.: MDUSBARMDPMINI System requirements Windows 98, XP, 2000 or Vista CD-ROM drive USB Port Keil uVision3 IDE/Debugger Software...
- Page 2 Driver Installation 1 To install the driver, you need to install the Keil uVision3 IDE/Debugger software. 2 Connect the ARM JTAG-ICE Programmer/Debugger to your PC via USB port. Windows will detect a new hardware.
- Page 3 Windows will automatically install the driver for device.
- Page 4 Hardware Configuration 1. Hardware Configuration is the basal setting to configure the ARM JTAG-ICE Programmer/Debugger, this section dose not include usage of uVision3 IDE/Debugger software. Run the Keil uvision3 IDE/Debugger software: 2 Open a project:...
- Page 8 Now, ARM JTAG-ICE Debugger/Programmer is ready to be used.
- Page 9 Debugging and Programming 1. Connect the ARM JTAG-ICE Debugger/Programmer to the Host PC. 2. Connect the ARM JTAG-ICE Debugger/Programmer to your target board ARM JTAG interface. 3. Power up your target board. 4. Run the Keil uVision3 IDE/Debugger software. 5. Open a project (Example: MDFLY ARM LPC2013 Development board and sample code).
- Page 11 6. Debugging:...
- Page 12 Start Debug Session, sample code will be automatically downloaded to your target device.
- Page 13 7. Programming: If you want to download the sample code to your target board device, you need to stop the debug session first.
Need help?
Do you have a question about the ARM-JTAG1 and is the answer not in the manual?
Questions and answers