Page 1
Cast Stone Fire Pit Model No. CM140-046 FOR OUTDOOR USE ONLY DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE...
Page 2
IMPORTANT SAFETY WARNINGS READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR FIRE PIT. WARNING • Only use this Fire Pit on a hard, level, non-combustible, stable surface (concrete, ground etc.) capable of supporting the weight of the Fire Pit. Never use on wooden or other surfaces that could burn. •...
Assembly Instructions For Easiest Assembly: • When applicable, tighten all hardware connections by • To avoid losing any small components or hardware, hand first. Once the step is completed go back and assemble your product on a hard level surface that fully tighten all hardware. does not have cracks or openings. You may wish to lay down a blanket or similar, to avoid possible •...
Page 4
Assembly Instructions 1. Disassembling the Stone Base 2. Installing the Stone Bowl and Stone Base Disassemble the stone base (G) from the stone bowl (F) by removing the pre-installed 4 M8x55 bolts (FF), Place the stone bowl (F) on the stone base (G) and 4 M8 nuts (DD) and 8 washers (EE).
Note: Split wood generally burns better than round wood. All wood should be dry. Burning green wood will lead to a smoky ‘cold’ fire. Do not burn plastic as it gives off harmful smoke for both you and the environment. Charmate® is a registered trademark of: Sitro Group Australia Pty Ltd. www.gasmate.com.au Aber, Hamilton, N.Z. www.gasmate.co.nz...
Need help?
Do you have a question about the CM140-046 and is the answer not in the manual?
Questions and answers