Falcon G350/G450 Series Exerciser/Analyzer Quick Start Guide
Contents
What's in the box .......................................................................................................................................... 1
How to set up your system ........................................................................................................................... 1
Falcon G350/G450 Series Exerciser/Analyzer Quick Start Guide Contents What’s in the box ............................1 How to set up your system ........................... 1 Analyzer: How to connect to your device and operate the analyzer ............2 Step 1: Connect the SMA cables for analyzer use ................2 Step 2: Connect Thunderbolt 3 and Power ...................
Protocol Insight Falcon software version 1.x or later 5. To set up a Falcon G300 series, activate the SW license by providing the Computer ID of the controller PC to Protocol Insight. Note: this license activation step is not necessary for the Falcon G400 series since the license key is embedded in the instrument hardware at the factory.
9. Copy the license activation key into the top box “Please enter license key” and click the close button. Analyzer: How to connect to your device and operate the analyzer Step 1: Connect the SMA cables for analyzer use Note: the labels on the analyzer front panel are from the instrument perspective. A.
The Thunderbolt 3 connectors, which are USB Type-C connectors, do not support USB3.0. Step 3: Capture an analyzer trace 1. Launch the Falcon software. 2. Select Analyzer mode. 3. Configure the Simple or Advanced Trigger from the Tools menu if desired.
Exerciser: How to connect to your device and operate the exerciser Step 1: Connect the SMA cables for exerciser use Follow the instructions for the Analyzer above, but change the SMA cable connections by replacing C and D from Step 1 above above with E and F below. E.