Santa Fe Connect Start Here

Start Here!
You should have received the following items:
Santa Fe Connect Monitor
1
Santa Fe Connect Cable (2 Ft.)
2
Santa Fe Connect Cable (25 Ft.)
3
Santa Fe Connect Water Sensor
4
Santa Fe Connect Water Sensor Cable (25 Ft.)
5
Hanging Screw
6
To get started connecting your new dehumidifier to the cloud, please follow these simple steps:
Step 1: Plug in and turn on your dehumidifier.
Step 2: Choose placement of the Monitor. Position the Monitor onto the
back of your dehumidifier. The magnet on the back of the Monitor
will hold it in place, or position the Monitor somewhere within
25 feet of the dehumidifier using the hanging screw. DO NOT
place the Monitor on the exhaust grill of the dehumidifier.
Step 3: Attach the Santa Fe Connect Cable to the Monitor. Use only one
of the cables provided. Choose your cable based on the length
required to reach the Monitor.
Step 4: Attach the other end of the Santa Fe Connect Cable to your dehumidifier.
Step 5: This step is optional. Attach the Water Sensor to the Monitor using
the Water Sensor Cable. Position the Water Sensor onto the floor.
1
2
4
3
5
6
This diagram shows using the
2 Ft. Santa Fe Connect Cable.
For further distances, the
25 Ft. Santa Fe Connect
Cable and Hanging
Screw may be used.
Back
View
TS-1068 4/18 Rev B