Summary of Contents for Regulus HR 30W
- Page 1 Installation and Operation Manual HR 30W, HR 100 W Single-Room Heat Recovery Ventilation Units V 1.1 - 1 - - 1 -...
-
Page 2: Table Of Contents
CONTENTS 1.0 Introduction ..........................2 1.1 Description ......................... 2.0 Installation Conditions ......................3.0 Installation ..........................3.1 Initial preparation ......................3.2 Installing the Appliance ....................5 4.0 Electric Wiring ......................... 4.1 Wiring to the mains ..................... 6 4.2 Electrical wiring and output switching ................. 7 5.0 Maintenance .......................... -
Page 3: Installation Conditions
2.0 Installation Conditions 1. The unit is designed for installation in external walls with a thickness up to 280 mm. For wall thicknesses up to 500 mm an extension kit is available (EXT100). 2. The unit must be located so that the ambient temperature will not exceed 40°... -
Page 4: Installation
3.0 Installation 3.1 Initial preparation 1. After considering the site requirements (Section 2.0), select a suitable site for the unit and controllers. Before deciding on the final position for the unit, check there are no buried cables, pipes or obstructions in the wall. -
Page 5: Installing The Appliance
3.2 Installing the Appliance From inside 1. Slide the unit into the mounting hole and ensure that the cable grommet rear part of the mounting flange is flush with the inner wall (Fig. 6 and 7). NOTE: The HR100W and HR30W units require an external overhang of 60 mm. -
Page 6: Electric Wiring
4. Electric Wiring Voltage: 230 V/50 Hz Power input (normal speed) 12 W Power input (boost speed) 31 W 4.1 Wiring to the mains cable grommet 1. HR100W and HR30W units are equipped with a two-speed motor. 2. Wiring must be via a 3A circuit breaker min. -
Page 7: Electrical Wiring And Output Switching
4.2 Electrical wiring and output switching 1. basic wiring HR100W continuous boost speed HR100W continuous normal speed live live neutral neutral ground ground switch wiring (normal / boost speed) live terminal switch live live neutral neutral ground ground These units shall not be wired to lighting circuit! 2. -
Page 8: Maintenance
5. Maintenance 5.1 Cleaning 1. In addition to removing odours, providing fresh air and recovering heat, this unit extracts airborne grille grille impurities such as dust, dirt and grease. These gradually build up and detract from the efficiency and appearance of the unit. 2. -
Page 9: Ext 100 Extension
6. EXT 100 Extension Extension for HR100W or HR30W is needed for 280-500 mm thick walls. It comes with the ABS outer louvre already mounted that forms a collar overlapping by 15 mm, making good around the installation opening, helping to seal off the opening with a water-resistant putty. - Page 10 - 10 -...
- Page 11 EC DECLARATION OF CONFORMITY Manufacturer: Vent-Axia Limited Fleming Way, Crawley GB-RH109YX West Sussex Product: Single-Room Heat Recovery Ventilation Units, models: HR 25; HR 25 L; HR 25 XXL HR 30 ; HR 30 W HR 100 R; HR 100 RS; HR 100 W;...
- Page 12 WARRANTY CERTIFICATE HR 30W, HR 100 W Single-Room Heat Recovery Ventilation Unit Model: ..................Serial number: ............... Seller: ............Date of purchase: ....... WARRANTY CONDITIONS The Seller grants the Buyer a guarantee period of 24 months from the date of purchase.
Need help?
Do you have a question about the HR 30W and is the answer not in the manual?
Questions and answers