Adjusting Mode Of The Touch Sense Sensitivity; Initialization Of Parameters - Denon MC2000 Service Manual

4. Adjusting mode of the touch sense sensitivity

The unit can control the sensitivity of the touch sensor for the Jog Wheel in 9 steps (-4 to 0 to +4).
"-4" is the lowest sensitivity, and "+4" is the highest sensitivity.
The default setting is "0".
(1) Pressing (SHIFT+LOAD A+LOAD B) at the same time, then connect MC2000 to a PC.
(2) Press CUE, and switch the jog wheel that you want to adjust.
(e.g.) If you press CUE of the left side, only CUE of the left side turns on, and jog wheel of the left deck is chosen to
adjust it.
(3) Rotate the track selection knob, and adjust the sensitivity. The button lights according to the set sensitivity.
Adjust level -4
Buttons HOT CUE 1
2
-1
-4
(4) Press the track selection knob to memorize adjustment data.
(5) Press SHIFT, then the mode switches back from the sensitivity adjustment mode to the normal mode.

5. Initialization of parameters

Return to factory default setting.
(1) Pressing (SHIFT+BACK+FWD+LOAD B) at the same time, then connect MC2000 to a PC .
(2) Return to default setting, and these data (as follows) turn to factory default setting.
Upon completion of the adjustment, it automatically restarts, start in Normal mode.
Initialize Data
JW transmission interval time
Sensitivity of JOG Wheel
-3 -2
HOT CUE 2 HOT CUE 3
Left deck
3 4
0 1
-3 -2
Factory default
-1 0
LOOP IN LOOP OUT
2
-1
-4
4ms 3ms ⇔ 20ms
0
14
1 2 3
AUTO FX1/2-1 FX1/2-2
Right deck
3 4
0 1
-3 -2
Range
-4 ⇔ 4
4
FX1/2-3