Advertisement
Tools Needed:
12 mm wrench
13 mm socket
13 mm wrench
14 mm wrench or socket
15 mm socket
WD-40 or similar lubricant
WARNING: Do not use air tools on manifold nuts. Vibration
will damage 02 sensors.
1. Place car on lift and spray manifold nuts and rear muffler pipe
bolt with WD-40.
2. Disconnect 02 sensor behind catalyst. Use a 12mm or 13mm
socket or wrench to pull joint between rear muffler and catalyst.
3. Pull the six 15mm bolts holding down pipe to manifold. With
someone holding up muffler system, or support stand in place,
pull off rubber mounts. Remove system.
4. Fit new Track Pipe headers to manifold making sure gaskets
are in place. Tighten bolts.
5. Tighten all bolts and replace rubber hangers.
E36 Track Pipe
Installation Instructions
Advertisement
Table of Contents
Summary of Contents for Active E36
- Page 1 E36 Track Pipe Installation Instructions Tools Needed: 12 mm wrench 13 mm socket 13 mm wrench 14 mm wrench or socket 15 mm socket WD-40 or similar lubricant WARNING: Do not use air tools on manifold nuts. Vibration will damage 02 sensors.
- Page 2 Plug on new simulators and tie strap to fuel lines (OBD2 CARS ONLY) AA TRACK PIPE SYSTEM IS DESIGNED FOR OFF ROAD USE AND RACING APPLICATION ONLY.
Need help?
Do you have a question about the E36 and is the answer not in the manual?
Questions and answers