Name Of The Part Being Modified; Modifiable Axes; Manual Axis Adjustment And Test Area; Spring Values - Logitech X56 HOTAS User Manual

1. Name of the Part being Modified

This will either be the Stick or the Throttle unit for the X-56. If you wish to change the part
that you're not currently on, use the back button (5) to go back to the selection screen.

2. Modifiable Axes

This shows a list of all modifiable axes. The Stick has three modifiable axes:
- X Axis
- Y Axis
- Rudder Axis
The Throttle unit has six modifiable axes:
- Left Throttle
- Right Throttle
- Rotary 1
- Rotary 2
- Rotary 3
- Rotary 4

3. Manual Axis Adjustment and Test Area

This area will show you how the current response curves / dead zones / saturation points are
set up on the selected axis. You can also adjust the center deadzone, the range saturation,
physical saturation, and the response curve on the selected axis. There is also a cross-hair
which will show the physical position of the axis you are manipulating.

4. Spring Values

This is a reference section when you are adjusting the axes on the Stick. It will act as a guide
for axis modification, and you may choose differing axis curves or deadzones depending on
the Spring you have fitted to the Stick. If you are modifying the Throttle unit's axes you will
not see this reference section.
5. Back Button
Takes you to the device selection screen.
6. Physical Axis Adjustment Slider
Allows the ends of the axes, the far left and far right on the X Axis or full up and full down on
the Y Axis, to be moved inwards towards the center point. It is similar to setting up a deadzone
at the far ends of your axis.
English 18