Advertisement
Install the Controller Battery
1. Turn off the controller.
2. Install one 9V battery (not
included), matching the polarity
symbols (+ and –) marked inside
the battery compartment.
ON/OFF
Install Batteries in the BMW i8 Concept
1. Turn off the vehicle.
2. Use a coin to turn the battery cover latch to unlock it,
then open the battery compartment.
3. Insert five AA batteries (not included) matching the
polarity symbols (+ and –) marked inside, and replace
the battery cover. Lock the latch.
Wheel Alignment
If your vehicle pulls to the left, turn this switch toward R; if the
vehicle pulls to the right, turn this switch toward L.
© 2015 Regal Worldwide Trading LLC. All rights reserved.
RadioShack is a registered trademark used by Regal Worldwide
Trading LLC under license of Global Franchising Corporation.
6001353_UG_EN.indd 2
Pair the Controller
Before driving, you must pair the controller and vehicle. To
play with more than one BMW at the same time, pair each
vehicle separately.
1. Place the controller within 3 ft. (1m) of the vehicle.
2. Turn on the controller and then the vehicle. The
controller LED flashes quickly, and turns off when
paired.
Note: If pairing fails, turn off the controller and the
vehicle, move closer, and then try again.
ON/OFF
Battery Cover
Latch
LED
Flashing = Searching
Off = Paired
Lit = When a driving
key is pressed.
Indicates controller
battery power
Press the back of car to
turn on/off the headlight,
tail light and interior light.
Safety and Care
• Turn off your vehicle and controller when not in use.
• Not recommended for children under 6 years of age.
Adult supervision recommended at all times.
• A nearby CB radio can interfere with your vehicle's
control. If this happens, move the vehicle away from
the CB radio.
• Do not play with your vehicle in the street.
• Avoid collisions with people and objects.
Battery Notes:
• For best performance use only fresh alkaline batteries
of the required size and type. Do not mix old and new
batteries, or batteries of different capacities, types or
chemistries.
• Remove batteries during longer storage
periods.
• Dispose of the old batteries promptly and
properly. Do not burn or bury them.
FCC Information
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using
your equipment.
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Printed in China
08A15
6001353
8/21/2015 2:13:17 PM
Advertisement
