Samsung HL-R6767W Owner's Instructions Manual page 33

4
Press the ... or † button to select the
Antenna connection, then press the
ENTER button.
• Air : "Air" antenna signal
Cable : "Cable" antenna signal
Air+Cable : "Air" and "Cable"
antenna signals
• If the CableCARD is inserted into the
"CableCARD" slot on the rear panel,
"Cable" and "Air+Cable" are not
available.
When selecting Cable TV system:
Press the ENTER button to start the auto
program. By default, the cable TV system
is set to "STD".
If you want to select another type of
cable system, press the œ button
and use the ... or † button to select
Analog or Digital "STD", "HRC" or
"IRC". Press the ENTER button.
• STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected.
5
Press the √ button to select "Start", then
press the ENTER button to start the auto
program. The TV begins memorizing all
available stations. Press the ENTER button
at any time to interrupt the memorization
process.
Press the EXIT button to exit.
• The TV must be connected to an
antenna in order to receive digital TV
signals. Even if a particular channel
is deleted from the memory, you can
always tune to that channel directly
by using the number buttons on the
remote control.
Auto Program
Input
Select the antennas to memorize.
Picture
Air
Start
Cable
Sound Start
Air+Cable
Start
Channel
Setup
Listings
Move Enter
Auto Program
Select the cable system.
Input
Analog
Picture ✔
STD
HRC
Sound
IRC
Digital
Channel
✔
STD
Setup HRC
IRC
Listings
Move Enter
Auto Program
Select the cable system.
Input
Analog
Picture ✔
STD
HRC
Sound
IRC
Digital
Channel
✔
STD
Setup HRC
IRC
Listings
Move Enter
Auto Program
Auto Program in progress
Cable Channel 26
Stop
Enter
Return
Start
Return
Start
Return
Return
English - 33