LANYARD AND SAFETY PIN ........................PAGE 8 There may be state or local limitations on purchase, possession, and use of the LifeLite™. Verify local legal requirements in your state and locality to ensure you adhere to all legal requirements. The user assumes the BATTERY INSTALLATION ........................
Page 3
• Never point or discharge your launcher at anything you do not intend to shoot. Please note that the LifeLite operational use temperature is limited by the gas used. The LifeLite should only be used when the device temperature range is between 20° F and 120° F.
Avoid accidental exposure to eyes. Do not aim at aircraft. This is not a toy. Always supervise children. Additional safety information online SPECIFICATIONS Manufacturer: United Tactical Systems LLC FOR USE WITH PEPPERBALL ROUND PROJECTILES ® Fort Wayne, Indiana 46809 Made in the USA | PBLifelite.com SIZE: 11-1/4"...
OPERATIONAL INSTRUCTIONS LANYARD AND SAFETY PIN BATTERY INSTALLATION 1. PLACE THE LIFELITE™ IN SAFE MODE - Slide the 1. ATTACHING LANYARD - Insert the lanyard through the end opening of the LifeLite™ and loop through safety towards the rear of the launcher until it is fully covering the trigger.
Page 6
NOT been loaded 1. Make sure the LifeLite ™ with projectiles. 1. Place the LifeLite™ in safe mode. 2. Unscrew Puncture Ram from cartridge chamber 2. Locate the charging jack on the front of located in the front of the LifeLite .
STORING THE LIFELITE ™ If storing the LifeLite™ for an extended period and it is not intended to be used, replace the Puncture Ram without a CO cartridge in the chamber and ensure the launcher is free of projectiles.
Laser is projected. • Never use petroleum-based cleaning solvents or lubricants. 2. Secure the LifeLite™ in a horizontal position with • Never use cleaning solvents that come in aerosol cans. the trigger pointing up. 3. Once secure, shoot one round from the LifeLite™...
Page 9
CLEANING PROCEDURE ™ 5. Immediately after damp swabbing (to prevent wet powder from drying inside of launcher) follow 1. Clear LifeLite of all projectiles and CO cartridge normal procedure of loading CO cartridge into before attempting to clean launcher. If the LifeLite and dry fire launcher without projectiles.
• All out of warranty returns are subject to part and labor charges and require a pre-payment of shipping liable or obligated to buyer or to any third party in any manner for any (a) special, non-compensatory, charges prior to product being returned to the Customer by PepperBall ®.
Page 11
PepperBall A Division of United Tactical Systems, LLC ® www.PBLifelite.com | (888) 874-3491 28101 Ballard Drive, Suite F Lake Forest, IL 60045 Proudly Made in the USA 18/5/17...