Subaru J1010FL300 Installation Instructions Manual
Subaru J1010FL300 Installation Instructions Manual

Subaru J1010FL300 Installation Instructions Manual

Impreza sport mesh grille

Advertisement

Quick Links

INSTALLATION
INSTRUCTIONS

TOOLS REQUIRED:

50/50 Mixture
Rubbing Alcohol / Water
COMPLETED INSTALL
PART NUMBER:
J1010FL300
Kit Contents: Sport Mesh Grille

PRECAUTIONS

1. When installing this product, park the car on a level ground and apply the
parking brake.
2. All vehicle clips will be re-used. Please store in a safe location.
3. Find a helper to assist with maneuvering the front bumper.
4. Be careful around painted surfaces to prevent any damage.
5. Do not use excessive force during any parts removal or installation.
6. After installing this product, check that it is securely attached.
ISSUE
01
PART NUMBER: J1010FL300
DESCRIPTION:
Impreza Sport Mesh Grille
SUBARU OF AMERICA
PAGE
1/7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the J1010FL300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Subaru J1010FL300

  • Page 1 PART NUMBER: J1010FL300 INSTALLATION DESCRIPTION: INSTRUCTIONS Impreza Sport Mesh Grille Kit Contents: Sport Mesh Grille TOOLS REQUIRED: PRECAUTIONS 1. When installing this product, park the car on a level ground and apply the parking brake. 2. All vehicle clips will be re-used. Please store in a safe location.
  • Page 2 PART NUMBER: J1010FL300 Disconnect negative battery cable. Wash front bumper with 50/50 mixture of water and rubbing alcohol. Apply protective tape over the areas indicated on the bumper and on the quarter panel - both sides. PAGE PART NUMBER: ISSUE...
  • Page 3 PART NUMBER: J1010FL300 Remove the bolts, clips and highlighted cover below. For the small clips, push button and then remove. Remove small clip from both rear facing sides of the front bumper. Push button and remove. Remove the 10x highlighted clips below.
  • Page 4 PART NUMBER: J1010FL300 Carefully pull out each side of the front bumper. For vehicles with fog lights, reach behind front bumper and disconnect fog light connector. Note the location of the front bumper tabs in the right image. Carefully pull the front bumper to disengage remaining tabs.
  • Page 5 PART NUMBER: J1010FL300 Use a screwdriver to remove the 8 screws from the back of the bumper. Push the upper & lower tabs as indicated in the image below while pushing the grille from the back towards the front to remove.
  • Page 6 PART NUMBER: J1010FL300 Carefully, reposition front bumper onto vehicle. Tip: Ask a helper to lift the opposite side for precise positioning. See Step 14's diagram to check stacking sequence between bumper and black plastic covers. Engage the front tabs. With the bumper is securely supported, reconnect the fog lights on both sides. Then carefully and precisely engage the side tabs on both sides.
  • Page 7 PART NUMBER: J1010FL300 Reinstall small clip. Push pointy end to reset clip and then insert into bumper and push button to engage. Reinstall the cover, clips and torque bolts to 7.5 N·m (5.5 ft-lbs). Reset small clips prior to install.

Table of Contents