Download
Share
Print this page
  1. Manuals
  2. Brands
  3. SparkMaker Manuals
  4. 3D Printers
  5. SparkMaker
  6. Instructions manual

SparkMaker Instructions Manual

Sla 3d printer
Hide thumbs

Advertisement

Quick Links

Download this manual
The Instructions of SparkMaker

Advertisement

loading
Need help?

Need help?

Do you have a question about the SparkMaker and is the answer not in the manual?

Questions and answers

Summary of Contents for SparkMaker SparkMaker

  • Page 1 The Instructions of SparkMaker...
  • Page 2 Part I Specifications of SparkMaker Build Volume 98mm*55mm*125mm XY Accuracy 100μm Z Accuracy 20-100μm Print Material Resin Print time 8-15 S/layer Connectivity SD Card Printer Control Interactive Push-button UV Backlight 400-410nm 24W UV LED Software SparkStudio Stepper Motor Driver 1/128 Micro step Hardware Dimensions Φ170mm*275mm...
  • Page 3 Part II How to use SparkMaker...
  • Page 4 Step1: Add STL file model to SparkStudio to add support and slice Step2: Save the slice file to SD card. Step3: Level platform when first print (No need to level again next time).
  • Page 5 Step4: Loosen the four screws on both sides of the platform. Step5: Rotate the knob drops the platform to the lowest point.
  • Page 6 Step6: Press down the platform and tighten the four screws on both sides of the platform. Step7: Pour the resin into resin tank (Less than 120g resin).
  • Page 7 Step8: Insert the SD card into the slot (Face down). Step9: Press the button and start to print.
  • Page 8 Step10: The print is finished. Step11: Loosen the handle and remove the platform.
  • Page 9 Step12: Remove the supports of model. Step13: Clean the model with 99% alcohol.

  • Page 10: How To Update The Firmware

    Step14: Irradiate the model with UV-light about 2-3mins. Step15: Finally, get the model. How to update the firmware a．Download the latest firmware from SparkMaker website.（www.sparkmaker3d.com） b．Unzip the files and save the update.wow file in SD card. c．Turn off the power of SparkMaker.

  • Page 11: Matters Needing Attention

    Step 3: Connect the Power Supply to Sparkmaker using the power cable supplied. Sparkmaker will make some noise when the power source is connected successfully. Step 4: Insert the SD card into the Card Slot in front of the Sparkmaker and the 3D printer light will start flashing in green.
  • Page 12 2. Insert the SD card, press the button, it will start printing and the light will be turn red. 3. If SparkMaker is printing, press the button, after it finishes the current layer it is printing, it will pause and the printing platform will raise up 20mm, so you can check the printing status. Press the button again, and it will lower down 20mm and continue printing.
  • Page 13 Can SparkMaker resin be used in other SLA printers? The SparkMaker resin can be used in LCD-SLA 3D printers that use PEFT film or FEP film resin tanks, and curing wavelength between 355-420nm. Why does the light turn red but turn green soon after when I insert the SD card and push the button to print? 1.