1. Manuals
  2. Brands
  3. Eumitcom Manuals
  4. Wireless Access Point
  5. WA3001A
  6. Quick installation manual

Eumitcom WA3001A Quick Installation Manual

Wlan 11mbps access point
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Eumitcom
Eumticom Technlolgy Inc.

Quick Installation Guide

of
WLAN 11Mbps Access Point
WA3001A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WA3001A and is the answer not in the manual?

Questions and answers

Summary of Contents for Eumitcom WA3001A

  • Page 1: Quick Installation Guide

    Eumitcom Eumticom Technlolgy Inc. Quick Installation Guide WLAN 11Mbps Access Point WA3001A...
  • Page 2 Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 3 the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages. This document contains materials protected by copyright. All rights are reserved.
  • Page 4 Introduction Area WA3001A is an 11Mbps Access Point that bridges between wired Local Network and one or more wireless mobile PC based stations. Connected to the Ethernet backbone through RJ-45 connector, the single Access Point wirelessly provides multiple data access with verity of mobile desktop or laptop PC in covered propagation range.
  • Page 5 Hardware Installation 1. Connect the AP RJ45 port to a Ethernet 10BaseT Hub. 2. Connect the power adapter to power source and plug it into power hole of III. Software Installation Following descriptions describe the steps to install the AP Utility 1.
  • Page 6 3. If an AP is detected, the utility program will show the AP information . 4. Double click the found AP from the list table. 5. Input the IP Address, subnet mask and default gateway correctly, click the “OK” button, you MUST assign the AP IP address with the value that is located within the same subnet of the configured PC.
  • Page 7 Notice : Eumitcom Technology Inc. reserves the right to change specifications detailed in this document at any time without notice, and assumes no responsibility for any errors within this document. Eumitcom Eumitcom Eumitcom Eumitcom Eumitcom Technology Inc. 2F, No. 2, Li Hsin Rd., Science-Based Industrial Park Hsinchu 300, Taiwan, R.O.C.

Table of Contents