PARTS
Congratulations! Thank You for
BEFORE USING YOUR HAIRLESS, PLEASE
READ THIS INSTRUCTION MANUAL
purchasing NuBrilliance
TM
Hairless
TM
!
CAREFULLY AND COMPLETELY.
Amazing Results!
ULTIM ATE
NuBrilliance
TM
Hairless
TM
removes facial
Important Safeguards/Warning
HAIR REMOVER
hair gently, safely & instantly.
1. Use Hairless
described in this instruction manual.
Protective
2. Hairless
Cover
one person only. For hygienic reason,
the hair removal head should not be
Hair Removal
shared with others.
Head
3. If you have any skin conditions or
other medical issues, please consult
Built-in Light
with your physician prior to use.
Slide ON/OFF
4. Do not use on skin that is red, irritated,
Switch
inflamed, infected or blistered.
5. Do not use on warts, sores or open
wounds.
6. Discontinue use immediately if you
experience any pain or irritation.
7. Do not continually rub the unit on the
same area or apply strong pressure.
8. Overusage may cause skin irritation.
Battery Cover
I NSTRU C TI O N M A N UA L
9. Exercise caution when using around
eyes.
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS
10. This appliance is not intended for use
Battery Installation
by persons, including children, with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction concern-
TM
only for purposes
ing the use of the appliance by a
person responsible for their safety.
TM
is recommended for use on
11. Keep your unit out of reach of
1. Open the battery cover by turning it
children.
counter-clockwise. Lift it off to reveal the
12. Do not place or store your unit in
battery compartment (Fig. 1).
direct sunlight. Please store your unit in a
cool, dry place at a temperature
2. Insert 1 x AA battery (not included)
between 0-40°C. Keep the appliance
into the battery compartment. Observe
dry when it is not in use.
polarity (Fig. 1).
13. Do not turn your unit on if the hair
removal head is not attached.
3. Close the battery compartment by
14. Do not drop or insert anything into
placing the cover back on and then
any opening of the unit.
turning it clockwise until it clicks into
15. Do not disassemble this device.
place and locks.
16. Keep the protective cover on your
unit when it is not in use.
SAVE THESE INSTRUCTIONS.
FOR HOUSEHOLD USE ONLY
BATTERY INSTALLATION
USAGE
Usage
4. Stop and check often if you have
achieved the results you desire.
1. Remove the protective cover from the
unit (Fig. 2).
5. Turn off the unit by sliding the ON/OFF
switch down.
Fig.1
6. Place the protective cover back on.
NOTE: It is normal for the hair removal
Fig.2
head to become warm with use.
NOTE: It is gentle enough to use every
day.
Fig.3
2. Turn on the unit by sliding the ON/OFF
switch up (Fig. 3). The built-in light will
also turn on automatically.
3. To remove hair, move the device in
circular motions, applying gentle
pressure over the desired area.
Do not press hard.
USAGE
CLEANING
Cleaning
lifting it off (Fig. 4).
Clean the appliance after each use to
4. The hair removal head comes apart
ensure best performance.
as shown in Fig. 5. Be careful not to
misplace any of the 4 parts.
Fig.4
5. Empty any hair residue into a trash
White Ring
can. NuBrilliance
resistant (IPX4), and it can be rinsed
under water for cleaning.
Blade
6. Assemble all parts in order
as per Fig. 5.
Blade Shield
7. Close the unit by placing the hair
Blade
removal head back on and then turning
Cover
it clockwise until it clicks into place and
Fig.5
locks.
1. Make sure the unit is turned off.
8. Place the protective cover back on.
2. Remove the protective cover from the
9. Wipe the unit with a lightly moistened
unit.
cloth. Do not use abrasive cleaners.
3. Remove the hair removal head by
turning it counter-clockwise and then
CLEANING
TM
Hairless
TM
is water
Customer Service: 1-800-423-4248
Need help?
Do you have a question about the Hairless and is the answer not in the manual?
Questions and answers