Advertisement
TMAA03-09/TMAA03-12 Plinth Installation Kit
Installation Instructions
Introduction
The TMAA03-09 plinth installation kit (for 25W radios) and the TMAA03-12 plinth
installation kit (for 30–50W radios) are used for desktop installation of mobile radios.
The plinth can be placed on the desk or on the TMAA13 power supply.
The plinth installation kits are
supplied with an 8 foot (2.5m)
power cable, four thumb screws to
attach the mobile radio and a
microphone clip (with screws and
washers).
The connector plug on the power
cable differs for 25W and 30–
50W mobile radios. Ensure that
you have the plinth installation kit
that is appropriate for your radio.
Installation
Mounting the microphone clip
The microphone clip can be mounted on
either side of the plinth, allowing for left-
handed or right-handed use.
Mount the microphone clip to the side of
■
the plinth with the supplied screws and
washers.
© Tait Limited May 2012
www.taitradio.com
402-00079-00
power cable
microphone clip
3 screws
3 washers
microphone clip
mounting holes
4 thumb screws
microphone clip
plinth
Advertisement
Table of Contents
Summary of Contents for Tait TMAA03-09
- Page 1 Installation Instructions Introduction The TMAA03-09 plinth installation kit (for 25W radios) and the TMAA03-12 plinth installation kit (for 30–50W radios) are used for desktop installation of mobile radios. The plinth can be placed on the desk or on the TMAA13 power supply.
-
Page 2: More Information
6 Turn on the radio and make sure that it operates satisfactorily, as described in the user documentation for the radio. More Information Refer to your radio provider for more information about this product. TMAA03-09/TMAA03-12 Plinth Installation Kit © Tait Limited May 2012...
Need help?
Do you have a question about the TMAA03-09 and is the answer not in the manual?
Questions and answers