Advertisement
Table of Contents
FRESHWATER AG+
The FreshWater
adapter gives a Hot Spring
Ag+
FreshWater
Silver Ion Cartridge and ACE
Ag+
illustrate how to attach the FreshWater
FreshWater
Ag+
attached to a Hot Spring Filter
(Tri-X
or Standard Paper 30 sq. ft)
®
Hot Spring Installation:
1. Attach the FreshWater
Cartridge to the FreshWater
2. Remove the filter cap with cell, and filter.
3. Place FreshWater
standpipe resting it on the botom of the filter
bucket.
4. Replace filter, lower ACE cell into standpipe, and fasten the filter using the ACE filter cap.
NOTE: Once installed, the FreshWater
filter by lifting and twisting the FreshWater
ACE ADAPTER INSTALLATION INSTRUCTIONS
®
Ag+
Adapter
Silver Ion
Ag+
adapter.
Ag+
adapter around the
Ag+
Ag+
Spa or Limelight
®
System simultaneously. The following instructions
®
adapter to either a Hot Spring
attached to a Limelight Filter
Silver Ion Cartridge may be removed without removing the
Silver Ion Cartridge.
Ag+
hot tub owner the ability to use the
®
Spa or a Limelight
®
FreshWater
Adapter
Ag+
(65 sq. ft.)
=
hot tub:
®
Advertisement
Table of Contents
Summary of Contents for FreshWater AG+
- Page 1 4. Replace filter, lower ACE cell into standpipe, and fasten the filter using the ACE filter cap. NOTE: Once installed, the FreshWater Silver Ion Cartridge may be removed without removing the filter by lifting and twisting the FreshWater Silver Ion Cartridge.
- Page 2 2. Remove the filter cap, and cell, 3. Place filter cap into large opening of the FreshWater adapter. Attach the filter cap. 4. Raise weir and lower the FreshWater Silver Ion Cartridge into small opening of the FreshWater adapter as shown below. Check for any interference between weir, adapter, and cartridge.
Need help?
Do you have a question about the AG+ and is the answer not in the manual?
Questions and answers