Table of Contents
Advertisement
A display similar to this one should be seen on the screen (the message
may vary from machine to machine).
activate.
If you don't get the display on your screen, turn the computer
off, wait a few seconds, and turn it on again.
9.
If you are using a color set, adjustment of the color and tint/hue depends
on the color controls provided on your TV set.
better than others.
10. If you have trouble with any of the above steps, consult the troubleshoot
ing chart in the VIC 20 instruction manual.
11. You can use a monitor instead of a TV set, in which case you can connect
the computer directly to the monitor input, without using the RF modulator.
TO AVOID CONFUSION ABOUT THE DISPLAY
Please note:
0
= the letter 0 as in Open.
0 = ZERO
1 = the letter I as in Input.
1 « the number ONE.
^
Cursor
PLUGGING IN THE PROGRAMMING CARTRIDGE THE FIRST TIME
1. Pick up the programming cartridge.
on top of the cartridge, remove it.
have pulled up on the socket release handle.
2. Make sure the BLOCK select DIP switch is set for BLOCK 5 (the left-most
switch is depressed at the top).
case, not the ones on the switches themselves.
to set BLOCK 5 and reset the other 3 blocks.
more than one of the rockers 1s set on at one time, the computer will not
operate properly.
3. Set the four toggle switches at the top of the cartrige so that they are
flipped towards you (toggle handles perpendicular to the top of the case).
The settings are:
Sometimes it takes a second or two to
**** CBM BASIC V2 ****
3583 BYTES FREE
READY
If an EPROM is installed in the socket
It will
Use the switch numbers embossed on the
SOCKET * ON
BURN/PR06 * PROG
MIMIC/PROG = PROG
EPROM » 2732
-7-
Some sets show some colors
lift out easily after you
Set it on conductive foam.
Use a dull pointed object
Avoid any other setting.
If
Advertisement
Table of Contents
