Table of Contents
Advertisement
Quick Links
Zebra 3 FM Instruction Manual
4. REPLACEMENT PARTS & ACCESSORIES
The following is a listing of replacement parts and
accessories available for the Zebra radio series from your hobby dealer.
A. TX Antenna (#58005)
B. Neck strap (#58311)
C. Trainer cord (#58318)
D. Switch harness (#57215S)
E. Heavy duty gold pin switch harness (#54407) This can be removed
F. Stick extensions (#56381)
G. Flight Preserver (#58480)
5. PRECAUTIONS
- Always turn your transmitter on first and off last.
- Never operate your system without first performing a proper range check.
- FCC regulation in the USA prohibits changing the crystal in your transmitter.
For channel changes send your system to an authorized service/repair center.
- Never fly around or over houses, people or power lines.
- Always charge your batteries before you fly.
- It's a good idea to check your receiver batteries with a tester
This will verify the charge level in your receiver batteries.
- Always fly responsibly and respect the rights of others.
- Make sure your frequency is clear before turning on your system.
Congratulations again and have fun!
Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland,
Ireland, The Netherland, Italy, Spain,
Norway, Portugal, United Kingdom,
Luxembourg, Sweden, Switzerland
MADE IN THE PHILIPPINES
8
Instruction Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Zebra 3 FM
Summary of Contents for Zebra 3 FM
- Page 1 Zebra 3 FM Instruction Manual 4. REPLACEMENT PARTS & ACCESSORIES The following is a listing of replacement parts and accessories available for the Zebra radio series from your hobby dealer. A. TX Antenna (#58005) B. Neck strap (#58311) C. Trainer cord (#58318) D.
- Page 2 CRYSTAL Thank you for purchasing the Zebra 3 FM digital proportional radio control system. The Zebra 3 FM is easy to use and utilizes the latest in solid-state components for FRONT unsurpassed reliability and performance. It is important that you read and understand this manual before you operate your system.
- Page 3 5. Always return the battery cover first before turning the transmitter power on. - The Zebra 3 FM Aero transmitters is equipped with a switch that will mix CH1 and CH2 for Elevon /V-tail aircraft, or common flying wing type aircraft.
- Page 4 After installation of the servo and receiver into your model is complete, - Zebra 3FM system is compatible with SIC (simulator interface cord- Part # 58318, not included) turn on the transmitter (fully extend the antenna) now turn on the receiver.
Need help?
Do you have a question about the 3 FM and is the answer not in the manual?
Questions and answers