JessEm 02230 Instructions Manual

DIGITAL READOUT
For Mast-R-Lift Excel II
Model # 02230
Thank you for choosing this product from JessEm Tool
Company. We appreciate your support and hope that
our product serves you well. This product is designed
to provide many years of reliable service provided it is
used as intended and taken care of.
This user manual will assist you in assembly and
general operation of this product. It is not our intent
to teach you about woodworking. It is assumed that
you are an experienced woodworker with the basic
skills and experience necessary to use this product
safely. If after reading the following instructions, if
you are unsure or uncomfortable about safely using
this product we urge you to seek additional
information through widely available woodworking
books or classes.
As As part of our Continuous Product Improvement
Policy, JessEm products are always advancing in
design and function. Therefore there may be
differences between what is shown in our catalogs,
website or at retail display and what is sold at time of
purchase. We reserve the right to make positive
changes to our products at our discretion.
Step 1: Plug in one end of the CAT 5E
Shielded Cable into the bottom of the Digital
Readout Display assembly. (Figure 1)
Figure 1
61 Forest Plain Road,
Oro-Medonte, Ontario L3V 0R4
Canada
866-272-7492 Toll Free
705-726-8233 Local Phone
705-726-7519 Fax
Email: jessem@jessem.com
Website: www.jessem.com
IMPORTANT!
Read and understand the contents of this
manual before assembly or operation of this
product.
Step 2: Attach the Digital Readout Display
Assembly to the back right of your Excel II
table top using the (4) 10-24 x ½" Torx
drive screw. (Figure 2)
Figure 2