Safety Information - Pioneer ES Series Operation & Maintenance Manual

WARRANTY CLAIMS
Contact the factory to file a warranty claim, before shipping parts back. Parts returned to the
factory without an RMA number on file will be scrapped upon arrival.

SAFETY INFORMATION

These warnings apply to Elite Series basic pumps. In many cases, Pioneer Pump, inc. has no
control over or particular knowledge of the power source that will be used. Therefore, refer to
the manual accompanying the power source before attempting to begin operation.
WARNING!!!
Before attempting to open or service the pump:
1. Familiarize yourself with this manual.
2. Disconnect or lock out the power source to ensure that the pump will remain
inoperative.
3. Check the temperature before opening any covers, plates or plugs.
4. Allow the pump to cool if overheated.
5. Close the suction and discharge valves.
6. Vent the pump slowly and cautiously.
7. Drain the Pump.
WARNING!!!
This pump is designed to handle mild industrial corrosives, residues and slurries containing
large entrained solids. Do not attempt to pump volatile, corrosive, or flammable materials that
may damage the pump or endanger personnel as a result of pump failure.
WARNING!!!
After the pump has been positioned, make certain that the pump and all piping connections are
tight, properly supported and secure before operation. (Refer to Installation section)
DANGER!!!
Do not operate the pump without the guards in place over the rotating parts. Exposed rotating
parts can catch clothing, fingers, or tools, causing severe injury to personnel.
5