Rockford Fosgate Detect-A-Finger Drop Probe Device Installation Manual page 24

SECTION 6—INSTALLATION OF LONG-STROKE DROP PROBE DEVICE
Detect-A-Finger™ Drop Probe Device - Riveter
Replacement Parts
Part
No. Part Name
N1-1 Frame Boss
N1-2 Frame — R.H.
N1-3 Frame — L.H.
N1-7 Drive Bushing
N1-8 Cam Bushing (not shown)
N2 Drive Assembly
N2-10 Drive Angle
N2-11 Drive Plug
N3 Upper Cam
N4 Lower Cam
N5 Lever
N6 Cam Plate
N7 Test Block Assembly
N8 Test Rod Clamp
N9 Test Arm
N10-1 Test Ring — Round
N10-2 Test Ring — Square
N10-3 Flanged Sensing Shield
Operation
Adjustments to Unit
Once installed, the unit has three simple adjustments. The ring can be
extended or retracted using screw 1 . The height and arm of the entire
test ring assembly can be set by screw 2 . The stroke of the assembly
can be set by screw 3 . (See Figure 6.8.)
Setting the Device
Set the test ring so that when held down against the bottom stop 4 ,
the ring just clears a properly aligned part. (See Figure 6.8.) It should
be set so that no obstacle, such as a finger, will fit between the ring
and the part or anvil. Set the stroke to allow easy loading and unloading
of parts.
Preliminary Check
Apply power and start the motor. The machine should be ready to
cycle. Upon the initiation of a signal for a riveting stroke, the test
ring will drop to the preset position allowing the signal, internally, to
be passed on to the clutch thus effecting a riveting stroke. Should
something prevent the test ring from dropping to the preset position,
the mechanism will lock and prevent any signal to the clutch. To
accomplish this, these devices must be properly applied, installed,
maintained and adjusted by the user. These devices cannot prevent
clutch or machine malfunction or repeat strokes of the machine. They
do not protect the operator if fingers are placed above the test ring.
Please refer to page 9 for other safety messages.
24
Part
No. Part Name
N10-4 Round — 1" I.D.,
Lexan Tube — state length
N10-7 Round — 1-3/4" I.D.,
Lexan Tube — state length
N10-8 Round — 2" I.D.,
Lexan Tube — state length
N11 Test Rod
N12 Test Nut
N13-1 Stop Assembly — Lower
N13-2 Stop Assembly — Upper
N14 Cam Shaft
N15 Stop Shaft
N16 Test Bushing
N17 Cam Pin
N18 Drive Spring
N19 Spring Rod
N20 Air Nut
N21 Micro Switch Nut
Part
No.
N24 Actuator — Lower
N25 Actuator — Upper
N26 Cover (not shown)
N29 Cam Bolt
N30 Test Bolt
N31 Cam Nut
N32 Stop Nut
N46 Electric Limit Switch
N47 Air Valve
Following Parts Not Illustrated
N53 Flow Control Valve
N56 Clutch Actuator Assembly
N61 Air Hose Assembly
1/4" I.D. x 5/8" O.D.
with Male and Swivel Female ends.
Specify fitting size and overall length
N70 Double Arm Assembly
N76 Air Cylinder Clutch Actuator
with Mounting Bracket and
Clutch Connector
1
3
2
4
Figure 6.8 - Adjustments to Unit
Part Name
D
C
B
A
Rockford Systems, LLC
Call: 1-800-922-7533