MySwing Professional Quick Start Manuals

STEP 1 MYSWING PROFESSIONAL INCLUDES: STEP 2 IMPORTANT
Keep Away From Magnetic Fields.
3 Feet
Case Keyboard
Charging Case Body Sensor ×17 Shaft Sensor ×2 Receiver
Tablet Body Sensor Base ×15 Shoulder Harness Transformer for Charging Case
MySwing Pro sensors must always be kept at least 3 feet away from all magnetic
elds. Magnetizing a sensor will cause noticeable errors in the avatar. If this occurs
repeatedly, contact Customer Service to have the sensor recalibrated or replaced.
Velcro Straps ×15 Antenna
Shoulder Harness
STEP 3 GETTING STARTED
STEP 3 GETTING STARTED PART 1 PART 2
Connect the straps to the sensor bases. Place the sensors into the bases.
Rotate the sensors 90 degrees counter-clockwise. Handle the sensors gently,
do not over tighten.
Use the appropriate length of strap that ts the player for each segment. Attach
the straps according to the diagram.
Attach the appropriate label (e.g. forearm, thigh, etc.) to the straps, if desired.
STEP 3 GETTING STARTED
PART 3 STEP 4 THE SENSOR LED'S PART 1
To turn on, hold the button for 2 seconds.
Attach shaft sensor just below the grip with charging contacts pointing down.
To turn off, hold the button for 5 seconds.
Align the shaft sensor parallel to the club face as shown.
To reset sensor, turn on, then hold the button for 10 seconds.
( Sensor must be fully recharged after reset. )
LED Colors
Green ( frequency 1 ) is the default.
( multiple systems in close proximity must use different frequencies )
Parallel
frequency 1 frequency 2
frequency 4 frequency 5
STEP 4 THE SENSOR LED'S PART 2 STEP 5 CONNECT TO TABLET
LED Status Start mySwing Professional software.
Add new student by clicking the plus
Enter Student's Information, Height, Wingspan, and Agree to the Terms of Use.
Slow Blink Standby
Proceed to Screen/Swing Tab.
Fast Blink Working
Click on the Connect icon
Double Blink every 3
Sleep Mode
seconds
Indicates Low Battery
Blinking Red LED
( approximately 20 minutes remaining )
frequency 3
Constant Red Light
Sensor Error
outside of charging dock ( Reset Sensor )
charging, low battery,
or sensor error
button.
and follow the on-screen instructions.