This document has been prepared with great care and the information it contains is assumed to be accurate. However, VDH Products does not accept any liability for eventual mistakes and errors and reserves the right to alter or adapt the document without notice.
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 3 of 16 Technical specifications General Type : MC 785 CHILLER Housing : Panel-mounted steel plate Material : Silver grey steel plate Dimensions...
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 6 of 16 Operation During normal operation the top left-hand display shows the INLET temperature, the top right-hand the OUTLET temperature, and below left (SETPOINT) shows the OUTLET setpoint temperature.
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 7 of 16 Maximum compressor capacity. If contact input 4 of LMS Dig-in module 3 is closed, then only 1 compressor is active.
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 8 of 16 Parameter table. Description Range Unit Default Sensor settings P 01 Offset inlet temperature sensor-1 -10.0...+10.0 P 02 Offset outlet temperature sensor-2 -10.0...+10.0...
Page 9
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 9 of 16 Description Range Unit Default P120 Minimum adjustable temperature setpoint heater 0.0..+90.0 +30.0 P121 Maximum adjustable temperature setpoint heater 0.0..+90.0 +40.0...
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 10 of 16 Description Range Unit Default Alarm P300 Minimum temperature alarm sensor-1 0...+100.0 °C P301 Minimum temperature alarm sensor-2 0...+100.0 °C and exchanger sensors (LMS)
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 11 of 16 Sensor calibration With parameters P1, P2, P41, P42, P43 and P44 the temperature sensors can be calibrated. If a temperature sensor readout is 0.2 / C too high, for example, the offset of the appropriate temperature sensor should be set 0.2 / C lower.
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 12 of 16 Front Front view of the MC785-CHILLER panel-mounted model, drawing 021773...
User manual Document no. : 032189 Version : V1.5 MC 785 CHILLER-2 Customer: Heinen & Hopman Page: 14 of 16 Principle of LMS modules connections. Block diagram with I/O and network connections MC 785-CHILLER 2 drawing 071782w1...