Subscribe to Our Youtube Channel
Related Manuals for Tach-It 6110
Summary of Contents for Tach-It 6110
- Page 1 INSTRUCTION MANUAL FOR TACH-IT MODEL #6110 MANUAL/SEMI-AUTOMATIC DEFINITE LENGTH FOR PRESSURE SENSITIVE TAPES 9/2000...
- Page 2 FIGURE 1 TOP VIEW Photos Shown are of Model #6100-SS but all information is relevant for the Model #6110 SPLIT TAPE MANDREL CAN ACCOMMODATE 1 ROLL OF TAPE UP TO 2” WIDE OR 2 ROLLS OF TAPE UP TO 1” WIDE EACH...
- Page 3 FIGURE 2 BACK VIEW CONTROL PANEL TAPE MANDREL ON/OFF POWER SWITCH CORD...
- Page 4 FIGURE 3 CONTROL PANEL INDICATOR LIGHTS MODE BUTTON TO SWITCH BETWEEN MANUAL AND SEMI-AUTOMATIC MODES OF OPERATION DISPLAY REWIND BUTTON IN MANUAL MODE AND INCREASE LENGTH IN SEMI-AUTOMATIC MODE TAPE FEED BUTTON IN INDICATOR MANUAL MODE AND LIGHTS DECREASE LENGTH IN SEMI-AUTOMATIC MODE CUT BUTTON IN MANUAL MODE...
- Page 5 SECTION 1 – CAUTION AND SPECIFICATIONS BEFORE OPERATING THE MACHINE, READ THE COMPLETE OPERATOR’S MANUAL. NEVER HAVE THE POWER CORD OF THIS MACHINE PLUGGED INTO AN OUTLET WHEN ANY OF THE COVERS OF THIS MACHINE HAVE BEEN REMOVED. INSTALL AND OPERATE THIS MACHINE ONLY ON A FLAT, LEVEL, AND DRY SURFACE. USE ONLY THE SPECIFIED ELECTRICAL POWER INPUT WITH THIS MACHINE.
- Page 6 SECTION 2 – LOADING THE MACHINE WITH TAPE PLUG THE POWER CORD (SEE FIGURE 2) INTO THE PROPER ELECTRICAL OUTLET, MAKING SURE THE VOLTAGE OF THE OUTLET IS THE SAME AS THE VOLTAGE OF THE MACHINE. PLACE THE TAPE ON THE TAPE MANDREL SO THAT THE TAPE WHEN PULLED IS COMING OFF THE TOP OF THE ROLL AND THE ADHESIVE SIDE IS DOWN (SEE FIGURE 2).
- Page 7 SECTION 4 – USING THE MACHINE IN AUTOMATIC MODE LOAD THE TAPE AND TURN THE MACHINE ON AS DONE IN SECTION 2 PRESS THE MODE BUTTON (SEE FIGURE 3) AND THE INDICATOR LIGHT FOR AUTOMATIC WILL BE LIT AND A PIECE OF TAPE WILL BE DISPENSED TO THE SETTING OF THE DISPLAY (SEE FIGURE 3) USING THE REWIND TAPE BUTTON AND THE TAPE FEED BUTTON (SEE FIGURE 3), CHANGE THE NUMBER IN THE DISPLAY TO EQUAL THE LENGTH OF TAPE DESIRED.
- Page 8 FIGURE 4 TAPE TAPE THICKNESS THICKNESS ADJUSTING ADJUSTING KNOB KNOB LEVER BLADE ASSEMBLY BLADE REMOVAL HANDLE HINGED OPTICAL COVER SENSORS SECTION 6 – ADJUSTMENTS AND MAINTENANCE TAPE IS NOT FEEDING OUT STRAIGHT: DIFFERENT THICKNESS OF TAPE MAY FEED SLIGHTLY DIFFERENTLY CAUSING THE TAPE TO CURL OR NOT FEED OUT STRAIGHT. TO ALLEVIATE THIS PROBLEM, PRESS DOWN ON THE HINGED COVER LOCATED AT THE FRONT OF THE MACHINE (SEE FIGURE 1 AND 4).
Need help?
Do you have a question about the 6110 and is the answer not in the manual?
Questions and answers