HMDX JOLT User Manual And Warranty Information page 2

Depending on your device you may be prompted to enter a pairing code. I
"0000" as the code.
Your earbuds will automatically enter pairing mode.
Note: If you turn on your Jolt earbuds but haven't started the party yet, it w
power off after 2 minutes of unpaired inactivity. power off after 2 minutes of unpaired inactivity.
LOOK MA, NO HANDS!
When friends call asking to join the party – and you know they will –
answer the phone without disconnecting from your Jolt earbuds. Yes,
that's right. Your earbuds have hands–free calling too. How amazing is
that? Here's how it works:
1 1. Make sure your phone and earbuds are connected through Make sure your phone and earbuds are connected through
Bluetooth.
2. Answering and ending a call works the same way: simply click the
multifunction button on your Jolt.
A soft dry towel is all you need to clean off
your earbuds. Using water, harsh cleaners, or b d U i
anything else only starts messing with the
mechanics inside.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Any Changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits N t Thi i t h b
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the equipment off and on the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
t h h l
t t d d f d t l ith th li it
f prompted, enter
will automatically
3. If you'd rather not talk, hold down the multifunction button on your earbuds
fo or 2 seconds to ignore the call.
TH HE COOLEST PART: The Jolt earbuds know when a call is coming in and pauses
th he music before ringing. When you hang up, the music starts where it left off
– and so does the party If it's you making the call just start dialing from your and so does the party. If it s you making the call, just start dialing from your
ph hone, and the Jolt automatically does its hands‐free calling thing. Isn't it
re efreshing to know your speaker totally gets you?
Multifunction
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment..
This transmitter must not be co‐located or operating in conjunction with any
other antenna or transmitter.
Multifunction
earbuds earbuds