Advertisement
Quick Links
Record
1.
Connect the antenna to the 'RF IN' port on the
rear of the LabSat 3 Wideband.
3.
Ensure you have selected the correct record
settings (i.e. quantisation, bandwidth,
frequency).
5.
Drive the desired route.
TIP: Record at least 4 minutes of stationary data to allow for
acquisition later.
Quick Start Guide
2.
Place the antenna in the middle of the car roof.
4.
Press the 'REC' button to start recording.
6.
Press the 'REC' button again to stop recording.
www.labsat.co.uk
Advertisement
Related Manuals for LabSat 3 Wideband
Summary of Contents for LabSat 3 Wideband
- Page 1 Connect the antenna to the ‘RF IN’ port on the Place the antenna in the middle of the car roof. rear of the LabSat 3 Wideband. Ensure you have selected the correct record Press the ‘REC’ button to start recording.
- Page 2 ‘RF OUT’ port. TIP: Four demo scenarios are pre-loaded on the SSD. Press the ‘Play’ button. The Device Under Test should now be receiving the replayed satellite signal data, allowing realistic and repeatable testing to be carried out under controlled conditons. www.labsat.co.uk...