Taylor Technologies Phoenix v3.0 Upgrade Installation Instructions

Phoenix v3.0 Upgrade Installation Instructions
Need serial number and upgrade pin number from current Phoenix to upgrade!
• Power Phoenix on & immediately press and hold 0 to get to the Feature Code Menu
• Feature Code Screen enter: 0 0 0 0 0 to disable board and get upgrade pin
• Enter Your PIN Code to confirm: _ _ _ _
• Upgrade PIN number will be displayed
Removing Old Board
• Disconnect power supply and keypad cable from Phoenix
• Flip unit over and remove 4 back screws
• Flip unit over and remove front cover
• Remove 4 board screws
• Gently disconnect:
1) 8-pin output jack (multicolor cords)
2) LCD backlight (yellow/orange/red cable)
3) LCD power (yellow/orange/red cable)
4) Main Power connector (white)
• Remove old board from Phoenix
Installing New Board
• Reconnect cords to new board
1) 8-pin output jack (multicolor cords)
2) LCD backlight (Yellow at the top & Red at bottom)
3) LCD power (Yellow at the top & Red at bottom)
4) Main Power connector (white)
• Replace 4 board screws – DO NOT OVER TIGHTEN SCREWS
AS IT CAN BEND AND DAMAGE THE BOARD. THIS
DAMAGE IS NOT COVERED UNDER WARRANTY!
• Replace front cover, flip over and replace 4 back screws
MUST REPLACE FRONT COVER BEFORE POWERING
TOOL IN ORDER TO PREVENT TAMPER LOCKOUT MODE