Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for OZtrail CAM-H08-F
Summary of Contents for OZtrail CAM-H08-F
- Page 1 OWNERS MANUAL Patrol 8MP CAM-H08-F www.oztrail.com.au...
-
Page 2: Table Of Contents
CONTEN TS PAGE Contents Page Introduction Important Safety Precautions Product Specification Contents Getting to know your Camera Getting Started Camera Operation AV Output Connection to a Computer Troubleshooting Warranty... -
Page 3: Introduction
INTRODUCTI ON Congratulations on the purchase of your new camera. This manual contains important safety and operating information. Please read all the information carefully before you use the device to avoid accidents and keep it for future reference. Follow these important safety and operation instructions. - Page 4 yourself. Qualified personnel should perform repairs. • Disconnect or remove all power source from the camera before cleaning. • This product is not intended for commercial use. Household/personal use only. • To prevent software failure, never disconnect the product from a PC while file transferring is in progress •...
- Page 5 • Remove old or discharged batteries from the product. • Remove the batteries when the product will not be used for extended periods of time to prevent damage due to rusted or corroded batteries. • Never throw batteries into a fire, do not expose batteries to fire or other heat sources.
-
Page 6: Product Specification
PRODUCT SPECIFICATI O N • Video Resolution: 720P (1280 x 720 @ 30fps) • Still Image: 5MP, 8MP • Status LCD Screen • IP54 • Triggering Distance: 20m • Triggering Speed: 0.6secs • Sensor Angle: 40° • 34 IR Low Glow LED (850nm) •... -
Page 7: Contents
CONTEN TS Please make sure that the items shown below are included in the package. Should an item be missing, please contact the local retailer from which you purchased this product Trail Camera 1 piece Mounting Bracket and Accessories 1 piece Mounting Strap 1 piece USB Cable... -
Page 8: Getting To Know Your Camera
GETTING TO KNOW Y OUR CAMERA DEVICE OVERVIEW... - Page 9 LCD Screen Mode, Delay, Resolution Micro SD Slot USB Socket AV Output Down Menu IR LED Lens IR Sensor...
-
Page 10: Getting Started
GETTING STARTED POWER SUPPLY Please install batteries before using the camera. Open the camera case and remove the battery cover. Install 8 pieces of 1.5V AA batteries. Please make sure they are inserted as per the (+ and -) symbols. - Page 11 INSERTING MIC RO S D C ARD This camera does not have internal memory. You will need a Class 8 or higher Micro SD card and must be inserted for this camera to operate and record. 1. Turn off the camera 2.
- Page 12 MOUNTING STRAP The Mounting strap can be used to attached the camera to a tree or other object Position the camera and pull the loose end of the strap until the camera is firmly secured. To release the strap again, pull at the tab of the strap.
- Page 13 MOUNTING BRACKET You can mount the camera permanently on a wall or tree using the below fasteners supplied with this product. Tripod screw Lock nut Pivot bolts Mounting holes Hex Key Wall plugs Mounting screws Installation Tools required (not included) •...
- Page 14 Please Note: The supplied wall plugs are only suitable for mounting on concrete and stone. The camera can be tighten with the “Lock nut” . The camera positioning can be adjusted by loosening and tightening the “Pivot bolts”. The assembly material used must be suitable for the respective location.
-
Page 15: Camera Operation
CAMERA OPERATION MODES The camera has 4 modes for the camera move the switch to select between these. These modes will allow you to operate the camera for your specific purpose. OFF Mode This will turn off the camera. IRAIM Mode IRAIM (Infra-Red AIM) this will allow to camera to record only when motion is detected, it will record according to your Delay and Resolution settings. - Page 16 Press the “M” menu button to go through the different settings. Use the “OK” button to enter the setting and the “Up/Down” buttons to change the setting. Press the “M” button again to confirm the setting IMAGE MENU FUNCTION 12:00 Time Adjusts the time 2018...
- Page 17 number will be shown on the date stamp in the picture so you know which location the photo was from: 【1】/【2】/【3】/【4】/【5】 /【6】/【7】/【8】【9】 Battery Displays battery level: BA3 – Full BA2 – Half Full BA1 - Low BA0 – No battery camera will shutdown AUTO Mode Switching to AUTO mode will initiate a 5sec count down before...
- Page 18 depending on what has been set on the “Resolution” setting. RESOLUTION Setting The camera has 4 resolutions available for you to record your photo/video, use the switch to select your preference. Please note the video length for each video is 10 seconds. VID：Video with low Resolution.【720P 1280*720】...
-
Page 19: Av Output
activated and a photo has been taken it will wait 1min, 5min, 10min or 30min before it resets and a new photo can be taken. AV OUTPUT The camera can transfer the video signal to an external monitor or a television. Please follow below instructions to operate. -
Page 20: Connection To A Computer
CONNE CTING T O A COMP UTER Use the supplied USB cable to connect your camera to your computer. After connected to the computer “USB” will appear on the screen of the camera. Once inserted the computer the removable disk icon should be displayed on screen. -
Page 21: Troubleshooting
named "DCIM". Copy the photos or files to your computer. Note: when watching the videos on your computer, please ensure you are using the latest version of your media player. TROUBLESHOOTING Problem Solution The exposure from the Place your camera in a North or sun makes my images South facing location this will help not good. - Page 22 AV input for TV Check your TV manual on how to connect AV cables. Some TV may require a composite break-out cable or adapter which is not include in the product I cannot upload images Check all cable connections are to the PC secured.
-
Page 23: Warranty
WARRANTY OZtrail warrants this product against defects for a period of one year from the date of purchase. OZtrail will repair or replace the product, at its discretion, should a warrantable defect arise within the warranty period. If the exact model is unavailable a model of equivalent nature will be substituted at our discretion. - Page 24 You may also contact OZtrail Leisure Products, by phone: 1300 362 921, or in writing: PO Box 1110, Eagle Farm QLD 4009, by email: warranty@oztrail.com.au. The benefits under OZtrail’s warranty against defects are in addition to other rights and remedies under law in relation to goods.
- Page 25 Designed by: OZtrail Leisure Products 71 Charles Ulm Place, Eagle Farm, QLD 4009 AUSTRALIA P 1300 362 921 www.oztrail.com.au facebook.com/OZtrailAustralia...
Need help?
Do you have a question about the CAM-H08-F and is the answer not in the manual?
Questions and answers