Zonet Sky-USB BOX Quick Installation Manual

Sky-USB BOX Quick Installation Guide
1. Sky-USB BOX software Installation:
Execute the Setup file in the CD:\SkyPhone2000-rel-xxx\setup.exe.
2. Sky-USB BOX hardware Installation:
Plug in Sky-USB BOX to the USB Port
When new device is found, select "Install from CD-ROM". Driver will be installed
automatically
3. Download Skype and account registration: Go to
software and follow the instruction to install and to register an account for FREE.
4. When Skype and SkyPhone2000 start, system will open the warning windows. Choose "Allow
this program to use Skype" and click OK.
5.
Skype configuration
File \ Options \ Hand/Headsets
Audio In: set to USB Audio or SKYBOX
Audio Out: set to USB Audio or SKYBOX
Ringing: set to USB Audio or SKYBOX
Check "Use PC Ring"
Attention! Microsoft Windows usually automatically configure BOX (USB Audio) as the
default audio. Please go to Control Panel then Audio and Multimedia to configure to your
original sound card as the "Default audio device". It is recommended to check "Always
use default audio".
6. Phone Connection: Connect a regular house phone to "Phone"port.
(Optional)
If the same phone is used for both Public Switched Telephone Network "PSTN" and
Skype calls, connect an outside PSTN line to "Line" port.
7. Test Drive: Pick up the phone. Skype window should pop up. Use keyboard and type
"echo123" and then "Enter". Follow the voice instruction from the test site to record voice and
hear the recording. Hang up the phone and Skype window will become minimized.
(very important for Skype to work properly with SkyBOX.)
Page 1 of 2
www.skype.com to get the newest Skype